Knuckle Grease

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 11, 2016
Threads
20
Messages
65
Location
United States
Hello,

I'm doing the knuckle rebuild and I'm wondering what moly grease should I get. What product did you guys previously used? Would the Valvoline Moly fortified multi purpose grease work?
What about for the bearings?

Thanks,

Tico
 
I use the Caterpillar Ultra 5 Moly grease. It is 5% Moly and has a Timken test load of 60 lbs whereas Sta-lube does not advertise their moly content and their Timken test load is 45 lbs. Caterpillar grease is good stuff!
 
Hi all,

As long as the grease is "EP" rated you should be good to go. Using a well known brand like Valvoline certainly won't hurt.

Good luck with the knuckle rebuild!

Alan
 
Thanks what about for the wheel bearings?

I've seen where a couple of reputable MUD members have used this:

Z_qAwvicpEx-.JPG
 
I use the Caterpillar Ultra 5 Moly grease. It is 5% Moly and has a Timken test load of 60 lbs whereas Sta-lube does not advertise their moly content and their Timken test load is 45 lbs. Caterpillar grease is good stuff!

Where could I buy it?
 
I'm doing the knuckle rebuild as well. I'm glad I saw this before I used Moly grease on the wheel bearings. Apparently if you use moly on wheel bearings, with the high speed nature they may not fully rotate causing flat spots on the rollers. (moly is too slick) Synthetic wheel bearing grease it is!
 
I just did a knuckle rebuild a few months ago. I think I spent more time reading about grease than I did on the entire rebuild! I was literally dreamimg about grease from the late night researching. I bought and either returned or junk drawered more types of grease than I can remember during the rebuild. Kept coming home and reading on here about what I bought and changing my mind about it! What I ended up using was Valvoline Palladium for the moly and Mobil 1 Synthetic in the bearings. Can't say if those are working well or not because I haven't driven it much since. But with the price, availability and quality of these two, I feel I made the most informed choice I possibly could have.
 
I'm doing the knuckle rebuild as well. I'm glad I saw this before I used Moly grease on the wheel bearings. Apparently if you use moly on wheel bearings, with the high speed nature they may not fully rotate causing flat spots on the rollers. (moly is too slick) Synthetic wheel bearing grease it is!
So grease with moly is slicker then synthetic multipurpose bearing grease like green lucas 10330 x-tra heavy duty. The Lucas green has the factory recommended NLGI #2 rating for the birfs.
 
Back
Top Bottom