FJ40 Newbie

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 20, 2010
Threads
49
Messages
701
Location
Socal
Hi,

I have an Fj80, but like everybody else, have wanted a 40 forever. Long story short I have an opportunity to get a ‘71 that is complete, but rusty as heck, not New England rusty, but darn close. The truck has an extra set of axles (disc brakes), the jump seats, roof, doors, etc...and ran when it was parked.

My fear is that I’ll have to basically to do a LOT of patching, maybe replace the tub, but on the other hand these are getting harder to find all the time.

I’ll get some actual pics of the rig, but looks rougher than this.

1578273853951.webp


But not as bad as this

1578273958807.webp


Is it worth $2800 or should I keep looking?
 
Beauty is in the eye of the beholder.. need to have pictures. Usually you don't get alot for 2K. But it sounds like it has a couple things going for it.

Kevo
 
Ha. I would not use “beauty” anywhere near it, but maybe “complete”?

Thanks..stay tuned.
 
If the frame is rusted through and the body is junk, then it's a parts truck and $2800 is plenty (or too much). If it's solid enough to restore, it's still iffy. Add up what it will cost to replace the tub and all body panels, and you might be better off just finding a more expensive rig.
 
Body work sucks.

X2

Much easier to replace the drivetrain then mess with rust.

If still stock not sure if it's worth for parts unless you have another early 40 to use them on. Most update older cruisers to later parts like 2F, four speed and disc brake axles. Those later models with most early figure it was something they found cheap to fix a broken part. Few things like stamped bezel are a exception. I like the 65 fresh air vent on the side of the cowl on my 68. Only because it was a one year only part and direct bolt on until the 72 model.
 
Everything ran until it was parked. Like said if the frame is solid and the body is repairable not a bad price these days if its complete, assuming the engine will run. You probably know what you can find in your area and what they sell for. Body work sucks like mentioned, but its by far the cheapest to repair as long as you are not looking to build a show truck. A 4x8 sheet of sheet metal can be had for cheap, a welder, grinder and some body putty and most can be repaired fairly cheap if you do it yourself, a lot cheaper then rebuilding the engine, or trying to find a lot of missing parts. But a rust bucket is not for everyone.
 
Rust isn't referred to as "cancer" for no reason.
 
Rust isn't referred to as "cancer" for no reason.
Left untreated its bad. But it can be treated and some patients can survive, and surgery might be needed.

Cancer is usually stage 1 to stage 5. Stage 5 means its pretty much over. This is stage 10

1578273958807-jpeg.2174529
 
It looks better than mine as far as rust is concerned. Mine did run and drive though. How does the frame look?
 
Hey! The bezel isn't even upside down. That's a plus!
 
How many years do you want to work on it ?
 
Ha...I expect to work on it for many years, but to try and get it moving first and then go from there. Has paperwork, an extra set of axles and is $3k
 
Thanks for the feedback folks, love the ih8mud community, especially right now when the world has become a very uncertain place
 
Back
Top Bottom