Dyno tested and tuned

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 23, 2016
Threads
10
Messages
53
Location
oconomowoc wisconsin
I am having a heck of a time finding a shop in Wisconsin that can dyno test and tune my supercharged 95 LC. I am located near Milwaukee Wi but open to having my truck transported outside the state if need be. I am hoping someone has a suggestion that is located in a surrounding state or close.

Thanks!
 
As far as shops go, look for a shop that tunes Subies or Evos or if you have a high end shop that does GTRs or even some Lambos.
 
You'll need an AWD dyno (subaru shop) or pull the diff fuse and front driveshaft to run on a 2wd dyno.

I agree with slow95z, not really tuning to be done unless you've got standalone management.
 
Make sure you install a switch to turn your SC on and off.

ColeHerseeSwitch-MadMax.webp
 
What exactly are you trying to tune? You can not tune the stock ECU it is locked from the factory and no one has bothered to unlock it. If you are going piggyback I would not recommend it. If you are going standalone what are you using?


I am having a heck of a time finding a shop in Wisconsin that can dyno test and tune my supercharged 95 LC. I am located near Milwaukee Wi but open to having my truck transported outside the state if need be. I am hoping someone has a suggestion that is located in a surrounding state or close.

Thanks!
 
Sorry. It looks like that was a dumb question. It appears that I am running a little rich. I recently upgraded the exhaust system and the shop said that there was a lot of residue.
 
These trucks run very rich at WOT. Not much you can do about it, short of buying a standalone ECU.

Sorry. It looks like that was a dumb question. It appears that I am running a little rich. I recently upgraded the exhaust system and the shop said that there was a lot of residue.
 
These trucks run very rich at WOT. Not much you can do about it, short of buying a standalone ECU.
Plus if you run too lean you will blow the welds on your intake.
 
These trucks run very rich at WOT. Not much you can do about it, short of buying a standalone ECU.

I thought the SC 1FZ ran lean at WOT so that’s why we all put on bigger injectors and fuel pumps??
 
Who’s adding bigger injectors? I know some people went to the Supra pump but that doesn’t really make any difference since it’s not pump limited.

I thought the SC 1FZ ran lean at WOT so that’s why we all put on bigger injectors and fuel pumps??
 
Who’s adding bigger injectors? I know some people went to the Supra pump but that doesn’t really make any difference since it’s not pump limited.

IIRC there has been some discussion of this. I thought the OBD II rigs had marginal fuel supply at WOT and the OBD I rigs do not without piggyback systems ad/or 7th injectors etc ?
 
Back
Top Bottom