Dissent offroad modular front bumper (3 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Ok. Thanks. So, it's still build to order.

When I ordered mine in January, Ben quoted 8-12 weeks. Can't remember exactly but I think it was closer to 8 weeks when I got mine.
 
Even if you’re not patient, it’s still worth the wait!!’

@fireball Yah, I bet you were chompin at the bit. I now know the feeling. With my rig at Bens, I try not to call every day.
 
We are working on some new light inserts that will hopefully allow us to stock them in the near future! With all the different options it’s almost impossible to stock anything. The new design will allow all bumpers to be the same and just stock different lights or blank off plates.
 
Just placed an order for a front bumper, I forgot to ask Ben about it (emailed after but I know he's busy so I thought I'd ask in the thread) I am going to be adding a 1" bodylift in the near future. I notice early in the thread brackets were mentioned, but I saw in a PDF of installation instructions it said to drill the holes higher. Can anyone confirm the correct method for install with a 1" body lift? I went back to the post with install pics but they no longer work.
 
What Color is the truck in these pictures? Is it River Rock Green Mica?


Hey @benc ,

The color of the bumper looks pretty close to the rrgm color of the truck. What color from prismatic is the bumper? Is it evo gray from prismatic. I think I am leaning toward that vs. black. Is it as close as it looks in the pictures to the rrgm. Decisions Decisions... :hmm:. Any other color suggestions would be greatly appreciated. Thanks!
 
1986190
 
What does shipping usually run for these bumpers?
 
Anyone have suggestions for winches I should look for that will fit? I would prefer something used that I can rebuild if needed that doesn't cost very much..
 
I got the 12k X20 Smitybilt in my dissent front bumper, have to place the controller on the side most of the winch.
 
So I guess I thought that when I ordered the bullet and 3x3 cutouts they were cut out of the main bumper not an attached plate. I didn’t see this in the pictures of other bumpers, maybe I didn’t pay close enough attention. Is his how they have always been made?
6AE9AD4A-773E-4088-AF16-EB17770C08F5.jpeg


I just read about that these are the new light inserts I guess.
 
Last edited:
Got my aluminum front w/ 3x3 cutouts mounted up. Winch is a Warn M8000 with synthetic line, Factor 55 1" thick fairlead and flat splicer with rope guard. Fog lights are Rigid D-series SAE, custom tinted selective yellow with angle mount brackets.

View attachment 2037759
Do the angle brackets allow them to be point straight?
 

Users who are viewing this thread

Back
Top Bottom