did a SR today

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Pinion angle ?

Do I have to run a cv shaft with stock springs?(55's) or can I run a regular ds? here is a pic of the pinion angle I'm thinking for a regular driveshaft.
IMG_9917.webp
 
looking good!
 
that pinion angle looks all right, need more pics, looks like its comin along, where you located?
 
too tall said:
Do I have to run a cv shaft with stock springs?(55's) or can I run a regular ds? here is a pic of the pinion angle I'm thinking for a regular driveshaft.

I think you will want to run a cv shaft with that angle. I am SOA with flipped stock springs and I could not get the angles to work without a cv. I currently have zero vibes running an 85 minitruck front cv with an 87 minitruck non cv half on the other end.
 
looking good on the ps pump bracket. do you have any specs on the bracket or did you just eyeball it? I know there are several available out there, but I would rather make my own than pay $1oo.oo+ for one since I have the steel available at the moment.

mike
 
I had a look at one up close with a tape measure . I still have to align it properly but it looks like it'll work. The pump I got from an 84 volvo 240 . I also modified the pump using the write up from west texas offroad in the tech links page curious to see how it works.
 
i am running a CV with my 55 springs. Because of the droop and flex youre going to get with these, its probably a good idea. I have not run mine in this configuration without a CV though, so maybe it would work? Its expensive, and usually untimely, when you find out you should have.

-Dustin
 
no cv in mine for the past 5yrs no vibration . but i will get a cv shaft in there one day . my rear end is only moved back about a 1 1/2 inches .still using 40 springs . sm456 and AA long adapter . your drive shaft should be longer .taking some of the angle out of the u-joints compared to mine
IMG_0262 (Small).webp
 
Last edited:
I'm making my own (probably today) I'm getting paranoid now though .If i have to run a CV then I'll have to change my pinion angle and I wasn't planning on building the track bar with that much adjustment .I guess I could use all heims but I find they get a little noisy when it unloads under deceleration.My other truck is all heims and it clicks alot on the pavement .
 
Mace said:
It really depends if you like replacing broken springs on the trail.

If you don't mind it, then by all means leave the military wrap at the shackle end.

Can you explain this? Your saying the military wrap are no good? I have been thing about buying the HFS suspsion lift.
 
All cruiser springs have a military wrap at one end . The rule of thumb is to mount the military wrap at the fixed mounting point so that if you break the main leaf the axle will stay in it's position because of the wrap on the second leaf.
 
too tall said:
All cruiser springs have a military wrap at one end . The rule of thumb is to mount the military wrap at the fixed mounting point so that if you break the main leaf the axle will stay in it's position because of the wrap on the second leaf.

The HFS springs have the military wraps on both ends. Is that a good thing?
 
Back
Top Bottom