1966 FJ40 Knowledge Needed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 25, 2019
Threads
8
Messages
24
Location
Connecticut
Hello!
I have a 78’ FJ40 and am currently looking at a 66’ that’s been totally restored but have zero knowledge about the differences between the two. I know the 66’ will be 3 on the tree (never driven one of those but have been told it’s no more difficult) my 78’ is a 4 speed on the floor. I’ve been told it will be much slower...What else should I know about the differences? It’s too far away to test drive it myself, I’d be trusting paying someone to look it over for me. It’s not like it would be my daily driver, I’d just take it out in nice weather like my 78’.
Thanks in advance for any info you could share with me!
 
I have a 66 that I’ve been restoring for a bit now. I have never got it up to highway speeds, but would be happy to answer any questions you might have.
 
The gearing in the 78 and 66 are the same as far as top gear and diff ratios.
78 has about 20 ish more horses, and front disc brakes.

Throw a sniper efi on it and drive drive drive...
 
The head on a '66 is a 'siamese.' Be sure that your intake and exhaust are, apparently, decent, because the aftermarket for intake and exhaust manifold/header is more limited.

The 3-speed is non synchronized on first gear, which means that it kinda grinds if you have to shift into first with any speed.

Early 40's, generally, have better integrity body-wise.
 
I wouldn't worry about the differences. I would worry that I can't inspect it myself. The word 'Restoration' is often thrown about like drunk woman in a mosh pit. Make sure your Inspector knows early Land Cruisers and how to properly inspect a 'restored' vehicle.

Contact the LC Club local to where the vehicle is and ask for assistance.
 
I wouldn't worry about the differences. I would worry that I can't inspect it myself. The word 'Restoration' is often thrown about like drunk woman in a mosh pit. Make sure your Inspector knows early Land Cruisers and how to properly inspect a 'restored' vehicle.

Contact the LC Club local to where the vehicle is and ask for assistance.
I wasn’t aware of local land cruiser clubs, this is very good to know! Thanks!
 
I wouldn't worry about the differences. I would worry that I can't inspect it myself. The word 'Restoration' is often thrown about like drunk woman in a mosh pit. Make sure your Inspector knows early Land Cruisers and how to properly inspect a 'restored' vehicle.


Very very true. So much "restored" garbage out there today. Most dont even qualify as a refurbishment much less a restoration. If it has really shiny paint and armor all tires proceed with caution.
 
Very very true. So much "restored" garbage out there today. Most dont even qualify as a refurbishment much less a restoration. If it has really shiny paint and armor all tires proceed with caution.
Yes, I have noticed that. So many are also in rough shape and people are attempting to get 25-30k for them. No wonder some of the same ones have been for sale for months and months. I will post the one I was looking at. The guy hasn’t responded anyway, so maybe it’s not for sale anymore or he gave up on selling it, no clue. Frustrating when people don’t respond.
 

I’ve been searching everywhere for a spring green FJ40. I’d really more so like a 78’ that’s all original and the only non-original aspect is that it’s been painted spring green.
 
A '66 will have fork and ball front knuckles, not birfield.
Weaker, coarse spline axles and pinion gears, "F" engine with siamese ports.
Heavier sheet metal.
Smaller drive shaft flange bolts.
Brittle wiring. Look closely at the terminal strips that the headlights and horn use for distribution (low on inside front fenders, right behind the core support).
Gas tank on the inside, under the passenger seat.
No rear heater, maybe no heater at all (mine didn't).
Dual wiper motors instead of one.
Small brake master cylinder with ONE brake line that feed all eight manually adjusted wheel cylinders. No booster or discs. Dash mounted T-handle, transfercase parking brake.
Twist-lock rear window struts.
Single cut door/ignition key(s).

Check the roof cap for crappy edges on the fiberglass and bad repair attempts. The usual rust in the rear sill and corners.

Happy hunting!
 
Last edited:
A '66 will have fork and ball front knuckles, not birfield.
Weaker, coarse spline axles and pinion gears, "F" engine with siamese ports.
Heavier sheet metal.
Smaller drive shaft flange bolts.
Brittle wiring. Look closely at the terminal strips that the headlights and horn use for distribution (low on inside front fenders, right behind the core support).
Gas tank on the inside, under the passenger seat.
No rear heater, maybe no heater at all (mine didn't).
Dual wiper motors instead of one.
Small brake master cylinder with ONE brake line that feed all eight manually adjusted wheel cylinders. No booster or discs. Dash mounted T-handle, transfercase parking brake.
Twist-lock rear window struts.
Single cut door/ignition key(s).

Check the roof cap for crappy edges on the fiberglass and bad repair attempts. The usual rust in the rear sill and corners.

Happy hunting!
Thank you everyone! I’m passing on the one I was looking at. Still on the hunt for a spring green one! Let me know if you see one!
 
The gearing in the 78 and 66 are the same as far as top gear and diff ratios.
78 has about 20 ish more horses, and front disc brakes.

Throw a sniper efi on it and drive drive drive...


Doubt one is made to fit a F135.


A '66 will have fork and ball front knuckles, not birfield.
Weaker, coarse spline axles and pinion gears, "F" engine with siamese ports.
Heavier sheet metal.
Smaller drive shaft flange bolts.
Brittle wiring. Look closely at the terminal strips that the headlights and horn use for distribution (low on inside front fenders, right behind the core support).
Gas tank on the inside, under the passenger seat.
No rear heater, maybe no heater at all (mine didn't).
Dual wiper motors instead of one.
Small brake master cylinder with ONE brake line that feed all eight manually adjusted wheel cylinders. No booster or discs. Dash mounted T-handle, transfercase parking brake.
Twist-lock rear window struts.
Single cut door/ignition key(s).

Check the roof cap for crappy edges on the fiberglass and bad repair attempts. The usual rust in the rear sill and corners.

Happy hunting!


Many of these changes didn't happen for many years. Other than light metal Best buy a 1/79+ to avoid the rest.
 
Back
Top Bottom