Hello,
I have bought a 1978 BJ41 with a 2B engine and an H41 transmission. The previous owner has cut, shortened and re-welded the input shaft of the transmission (measurement of the shaft now is 8-1/8” from the end to the first gear), installed a shorter bell housing, a shorter bearing...
I don't know what specific symptoms this would cause (possibly excess vibration/ NVH), but when I went to install my trail tailor creeper skid, I learned that my transmission mount had come apart. The center rubber section was originally bonded to the lower plate that bolts to the crossmember...
I drove the car and it was driven daily by its owner.
Shifts well, no slippage, downshifts and upshifts as it should. No leaks, no shudder or vibration. Now out of 1991 Land Cruiser and waiting for a new owner. $550 firm. Ready to reinstall. Includes torque converter
Aisin carb from a ‘75. Just a rebuildable core, but I think it’s all there (someone please correct me on that if that’s incorrect). Located in southern middle TN. $75, obo, plus shipping. I have never used this carb, it was just in boxes of parts that came with my 40 when I bought it years ago...
Brand new, never used 1992-1996 land cruiser 80 series radiator, 3 core brass. I am willing to let it go for $100. I do not have time to ship it so local interest only, if you are willing to pick it up.
For sale new original part #12371-17010 Rear engine mount or Transmission mount (Insulator, Engine) for manual transmission used with 1HZ diesel engine. I bought it for my automatic A440F hoping to work it out, but found an original 12371-17020.
So I don't need this one. I paid about $80 and it...
My engine was rebuilt in the fall of 2021 and I installed a supercharger in the fall of 2022.
After installing the supercharger, normal operation has been great however under WOT the transmission shifts at 3400 rpm (PWR not engaged).
I've adjusted the throttle cable (kickdown) based on...
Hi Guys, new here and new to owning an 2001 LC100. I live in Botswana and I recently got one for a daily driver. It has a 4speed auto trans and the previous owner mentioned changing the trans at around 270k its at 285k rn. I have an ask, can I swap the 4speed for a 5speed in later models? I...
Took my '94 80 out for a 50 mile test drive after working on the instrument panel, LED lights, Apparently found problems in Cruise Control. On level highway all appeared OK. As the grade steepened I noticed that the speed would randomly, suddenly drop 2-3 MPH and recover in a second or two. This...
I've seen some posts in this regard but wanted to see if there is advice on my situation...noise when accelerating mostly in 4th...changed transmission fluid sounds a bit better but still noise. Any advice on cause? Would transfer case create what I'm hearing?
Thanks!
Does anyone in the CLT area have a transmission jack I can borrow/rent for a clutch and tcase rebuild job on my '84 FJ60?
Would need to have a big extension range as the rig has 2.5" heavy lift springs and 33's.
If you've done this job on a 60 before and recommend a particular budget jack to...
Hi im new to owning a land cruiser and am wondering where the best place to buy a torque converter would be. My transmission will not engage gears when put into drive, only has reverse, thinking about trying to do a rebuild on the transmission or throwing in my spare 440 i found, but im going to...
Speedometer bounce is gone. Replaced the speed sensor and not a bounce in a 15 mile test drive. And, a very important side benefit, the transmission hesitation I was also experiencing went away as well. Talked with my Toyota mechanic who indicated that speed sensor signal gets to the...
Replacing speed sensors and AT temp sensor and solidifying frayed wiring and connectors around transmission on my 94. Can anyone help me out with what the soft lines with the T are above the transmission right behind speed sensor 2? I can't figure out where they come from or where they go when...
Hi does anyone happen to have a junk or torn down a343 transmission from an 80 or 100 series? Looking for the output shaft. Please shoot me a PM if you do!!
1997 LX450. My OEM transmission cooler has done his time. Has anyone found an upgraded unit that they can recommend? Looking to replace the OEM unit and put the new unit at the same place. No need for fancy electric fan units for my use.
Thanks!