stuck

Hi all- my 1989 FJ62 drove fine yesterday, parked it in the driveway and this morning I can't get it into gear. The shifter will move out of park but not into gear. I haven't driven it in a week, apparently my wife noticed it being more difficult to keep the shifter into the park position. I am...

hey y'all. I hit a bad corner on Miller Jeep and I'm on my side and having a rough time pulling it over. Anybody in or near Frazier park feel like lending a hand? My buddies jeep is now 2 wheel drive due to trying to pull me over. Part of the problem is that there's no real wench point and...

Hey, 4 Hi engages fine via button on dash. 4 low shifter seems to be stuck in place, I am afraid to force it and severely damage something. Can not engage 4 low. Have not had time to get in there and look around. Figured it was worth reaching out to see if this is a common issue before I start...

I'm pretty sure my new to me LX sat for a bit before I bought it. When I press the sunroof retract button I hear a mechanical clunk but nothing moves (in both directions). My mechanic friend thinks the rubber gaskets may have gotten stuck (mildly bonded) to the surround from sitting to long or...

Hi H55F gurus! My gearbox is stuck in first gear. I have pulled the top off but can't budge the selectors. The weird thing is that when you accelerate up an incline it jams in first and it comes free sometimes on the level or when the truck is pointing down an incline. Any bright ideas...

Was posted in the San Diego Cruisers section but figured I'd post here...,Rth: stuck at salton sea Frank

Im axle deep into clay. If anyone around, please come pull me out 714-204-7758 Thanks Phuc

I'm currently stuck about half way up dickey bell. I put the t-case shifter in low and suddenly couldn't go forward and can't roll back. The shifter is just loose and floppy. Transmission shifter is fine and seems to engage but it feels like something is seized. Any advice? Recommendations for...

Went to leave for florida and got pulled over, no tail lights. Fuse blown and replaced with new, it pops instantly with headlight switch activation. I removed all six rear bulbs, and fuse still blows at switch activation. I thought at first it was me working on the back hatch as I was wet...

Turned on the A/C today for the first time in a while. The idle speed went up to 1500 RPM. Problem is when I turned the A/C off it stayed at 1500. Any suggestions? Thanks Jim

I'm trying to get my e-locker third to come out of the axle housing, but I can't get it out. I slide out out on the studs about 1/2 inch and then 'clunk' it hits something. What do I need to do? Thanks!

While in the process of getting the transmission out to replace a slipping clutch I got stuck the stage:

2003 LC lost all keys. Dealer says it needs new ECU they can get unitl next week. They are supposed to come home to TX on Sunday. Isnt it true they can do the key programing on an 03 with out replacing the ECU?

Hi guys. Rebuilding my axle and upon stripping the left hand side down both the upper and lower trunnion bearings are stuck to the spindles which they sit on. The right side stayed in there races but the leftside is giving me grief. I've broken the upper one trying to get it out. Any suggestions???

My 94 FZJ80 has been doing great and I've been slowly correcting the little things that bug me, but this morning a new issue arose. The truck turns on and runs just fine, but the gear shifter didn't want to leave park. After turning the truck off and on again, I eventually forced it out of...

I'm looking at a 2005 LC that i may be purchasing but the diff lock light is on.. I am not able to go and check out the vehicle before I purchase it so here I am asking all of you before i make this purchase. I am trying to figure out the scenarios and possible solutions for this diff lock...

Stuck in a Walmart parking lot in Tracy California. Rig won't start. It started and ran great, drove from San Fran to Tracy. Stopped for gas and when I got back in, it labored just a bit like the battery was being drained. I came to Walmart and came back out and it won't start. Tried jumping it...

Last night I swapped the positive batt lead, no issues. This morning my kid says fuse box came loose, some sparks, but truck restarted. Now, no power - he has just left to get a new multimeter (mine just died). Looking for ideas as to fault. Lights don't work, newer Batt (and no change w jump)...

Hello, I am doing a frame off restoration on a 1982 fj40. Now that the body is off I am addressing the emergency brake problem. It is completely stuck and is not the cable. This is the later style emergency brake. About to take the rear drums off but just wondering if since it is all one...

Any idea why my fresh pull knob feels like it is stuck in the outward position? Do I just need to lube her up?