stuck

Hey team — Doing an AHC globe replacement, and I’m trying to get the last 3 globes off my LX. Won’t budge. No rust, just the one’s tight (front driver) and the other I can’t get the 36mm wrench on the globe bolt because of the angle (rear driver)— need a different tool of some kind. For the...

[deleted]

Ok so I’ve never had this problem but the key won’t turn forward … It worked literally last week, but it’s been raining and cold and then warms and then back to rainy weather, not sure if moisture could have caused it or what but it won’t turn…ideas? Just fyi, I am going through a steering...

I’m attempting to disassemble my steering column to install a bushing (currently it’s loose in the firewall with a big gap). But I don’t know if I can get the shaft out? Should I be able to slide the ignition switch piece up toward the wheel? First pic. The FSM seems to skip some steps. The PO...

Yesterday I suddenly was not able to open my front door (driver side) anymore. It was completely stuck and I could not open it from the inside, outside or with the key. Luckily I was able to remove the door trim from the inside. This gave me the ability to disconnect the solenoid and to pull...

EDIT: The circuit boards for the TCM’s on both the original and the one I swapped in were messed up in different areas. My buddy with a 93 came over and we swapped his TCM in and it fixed my issues. I bought a 93 FZJ80 equipped with a A442F transmission the other week. The truck had been...

2010 LX570 156,000 I'm in Red River, NM with my family. LX has been great all week, supposed to leave today. LX was fine this morning for a quick errand, then a couple hours later I get in and start it up and it immediately jumps to 5000 RPM. When I shift to D it drops to normal for a...

I am at it again. I was so anxious today that I was changing all those bushes under my car. I expected to get the best experience after the change. Note that I was already having a very good experience, and in fact I should not have bothered to change anything - but there I was. All rubber...

Today, I was dragging my dump trailer out of a sloped/muddy area, so I popped it into 4LO. I then needed to get out of 4LO, but it was stuck in 4LO. It took about 30 minutes of randomly driving forward, driving backward, switching between 4LO/4HIGH, coasting in Neutral and restarting to pop it...

My powered drivers seat is stuck in the upright position. Everything I see regarding seat issues is how to fix it from sliding back and forth (which mine does too) but not how to decline it if it is stuck. I'm not opposed to dropping new seats in it but it seems options are limited and don't...

As the title states, my driver-side window is not working, and I plan to order a new motor and regulator. Looking online, prices range from $45 to about $120.....I'm new to this, so can someone point me in the right direction regarding brands or where to order from? If there is a specific part...

Hi guys! I've changed my spark plugs, spark plug seals, cap, wires and valve cover gasket yesterday. Engine (1FZ-FE) ran better than ever. But today I got a p0301 code (misfire cilinder 1). Upon further inspection I found fuel leaking from the exhaust gasket at the catalytic converter and fuel...

Trying to remove stuck windshield hinge screws to install side view mirrors. Everything is painted or I would try to heat the screw up to remove

Hi all, Never worked on brakes before but found out my rear caliper is stuck. Watched videos on YouTube and took it off the rotor. I opened the slides screws, they look clean inside. Pushed the pad against the piston with a 9" C-Clamp, worked. Started the car and pumped the brakes until ABS...

Filter on left is courtesy of Massey Ferguson while the right side is from Kubota.

Help! So, I recently discovered a minor leak in my KZJ78 transfer case, and I was able to pinpoint it to the small oil seal at the top of the transfer case where the shifter linkage goes into the transfer case. I managed to disconnect the bellcrank linkage from the selector shaft that...

Hi everyone. Went away recently I was in H4 and L4 most of the weekend. A few times when I was passing though towns I tried to slip it back in H2 and for the life of me I could not get it back in. Eventually I managed to slip it back in. Going into H4 N and L4 was easy just seemed to have the...

I’m pulling the trans and tcase as a unit from my 96 landcruiser. 1FZ and A343, usual spec. All the bolts are out, all connectors disconnected, followed the FSM directions. The trans absolutely refuses to separate from the motor. Pulling it from the crossmember mount to the frame with a come...

So I’ve got the second row passenger side seat that refuses to go up and forward. I’ve searched but haven’t found any hints as to how to access the inner workings, pop the striker or whatever. Does anybody have any sage advice before I start breaking more trim? It did this years ago and it...

Hi together, maybe someone can help me. Since I lost my second keyfob the winter before last winter (jepp the car gives a f*** if the key isn’t in the car if you didn’t turned it off sometimes) I decided now to get again a second one just to be safe. So I did some research, contacted some Toyo...