oil

hi guys ..can anyone tell me if theres anything special about the banjo bolt for the turbo oil feed ..is it restricted ..(small hole size ).. thread size =M11x1.25 ......I think? thanxs in advance

help I was tightening bolts underneath my lx then al the others were tighteneing well But this one broke now what?

Hey all. I've been getting a bit of oil in my coolant system for a few months now. Had it flushed. Now there's more. Anyone seen this or had any experience with it? Kinda freaking me out...

For a number of years (10?) my oil pressure gauge on my stock '78 FJ40 has indicated high oil pressure. All other gauges are accurate. I have had the truck for 27 years, and it seems that it has read higher-and-higher, as the years have gone by. My 2F has no better (or worse) oil pressure than...

I am getting ready to do my first DIY oil change on my 100 series. I see that people sometimes use a larger oil filter. When I lookup what fits my truck, it says WIX 51348. But I see some people using the larger WIX 51515. Does it make a difference which one is used?

I know the LX and LC call for Dexron but would Lucas Oil PSF (not the stop leak) really harm the system? It says it's compatible with all systems...Hmmm I wonder. I went to change mine and it was black so I took some out of the resevoir with a pump and refilled with Lucas Oil PSF. Drove around a...

greetings. I have this B engine 11411-56020 with a broken oil pump. I am tryng to find the spare part but here in Costa Rica it is almost impossible to find that part and neither on the internet, there I found a very look alike but don´t know if it will fit... By logic I need an 11301-56020...

So as winter drags on I start dreaming again. I bough a wakeboat the summer after buying my 40 and now don't want to tackle this project on my own/as a learning experience. I want this to simiply be a driver for the time being and want to get my drivetrain sorted out. I put only about 20 miles...

I have 3 nib dual stage oem toyota filters for sale. No longer available from toyota. Part # 15600-41010. $30.00 each shipped.

Hey guys, so how do you know if your getting a Hummer oil pan? When I look them up they say Hummer, Silverado, gmc, etc... does anyone have a picture of what the difference is, or will any LS 4x4 b pan work as far as driveline clearance

Just a heads up. I have had differential oil leaking out of the birdfields for many years. I recently read where removing the vent valve from the front differential might help. I removed the valve and ran 1/4 fuel hose from the original vent location up to the brake master cylinder and voila...

Just thought I would share that I have been running the WIX 51773 on my 87 FJ60 for a few years now. It is of larger capacity than standard 2F filters. It holds just over a quart. Not trying to start a discussion about which filter is best, which I consider a bit of a dead end since most...

Hi, Looking for a wire harness connector for 1991 fj-80 oil sending unit . Specter part no 184-310 works but can this be sourced else where ? Thanks, Mike

First oil change on the recently acquired rig and I was a little nervous with all of the sealant packed around the drain plug. I had a new OEM gasket on hand and went for it. Threads seemed ok, so I put new gasket on and snugged up the plug. Threads seem ok. Had a slow steady leak from the...

Hi Guys, 97' LX-450 125K. Small leaks from power steering pump and Oil leak under Engine. Very minor fluid loss. Shop, That is familiar with FJ80 says is O-Rings. Main on PS Pump, not Pump failure and Oil pump in engine leaks after time and pulley comes off, Repair is $450.00 or so. Should I...

Can someone who know this collaborate if it is normal to have water in the oil separator .

I have a 69 FJ40 with a 76 2f without the oil cooler and where I live I need to drive at least an hour to get to any trails and I don't have acess to a trailer and truck. I have the stock 3 speed which is less than ideal for the highway but my question is if a oil cooler is necessary. I've...

Other than synthetic, what is the optimal weight for temperature range of 10*f to 95*f Is it OK to use gear oil intended for limited slip differential or traction modifiers for a differential that's open or in the transfer case?

will these work too seperate oil from going into intake Primefit 100 psi Mini Brass Air Filter with 1/4 in. NPT-F1401 - The Home Depot 2. Primefit 100 psi Mini Brass Air Filter with 1/4 in. NPT-F1401 - The Home Depot

My oil sensor wire shorted to ground and bent the Oil Pressure gauge in the Cluster. I tried to fix it but no luck. Anyone know where to find one? This is what I need. Found the entire cluster on Flea Bay for 115. Keep getting errors trying to upload pic.