head

I have a pair of 79-83 FJ40 headrests for sale that came off my 79 seats. They are solid with no cracks but not perfect. Had to clean up the stems. They now need paint but I wanted to leave them bare so you can see what's there. One headrest shows some spots but may clean up better than I did...

This truck started out as a Supercharger and preventative head gasket install. Turns out the head gasket was already leaking and the head was really warped. Head is at the machine shop still being trued up. In the mean time we figured if we're going to make it faster, we should make it stop...

I just bought a 2001 LC with 201k miles that has a blown head gasket. I have replaced a few head gaskets before on various makes and models of cars so I was not too scared of buying something that needed some serious work. That and the vast knowledge of members and good threads on this site...

I recall reading that Toyota came out with a revised head gasket to address failures with the initial gaskets used at the factory. Is there a specific part number I should look for or just pick up what the Toyota dealer says is correct? On that note, can anyone confirm the part number? Thanks guys.

We've had a warm snap here in East Tennessee which gave me a chance to do a bit more work on the FZJ80 I bought in the Fall (no garage). The first job is baselining starting with engine work including replacing the head gasket. The truck has 230k on it, ran great and had really good/consistent...

I got he ERR3 code on my Lexus Premium disc changer (not Nakamichi), so it's time to go aftermarket. Through a bunch of reading on MUD and elsewhere, I gathered that replacing the amp would be wiser than trying to reuse it with a potentially incompatible head unit. I wanted to keep the budget...

Hello everyone I have a 2F engine block that has been professionally cleaned and fluxed. No issues with it at all, only some light rust gouges in one cylinder that should come out with an overbore. I also have the head from this 2F as well, but it has not been cleaned. I have most accessories...

Hi folks, I am in the middle of a head gskt replacement, head has been pressure tested and skimmed. I am thinking I should replace the cylinder head bolts as somme of the old ones looked shot and I am assuming they are stretch bolts anyway. I am having trouble here in Blighty tracking down...

Anyone have or know of a FSM for the 98+ FZ with the coil packs and redesigned head?

I have a spare 3FE head that I just brought into a local machine shop to be cleaned and evaluated, and was told that it needs pretty much everything replaced, including rotators and valves. It is a good head though, no cracks and minimal warpage. They said it would cost around $900 to get it...

I cracked my head last winter. I need a rebuildable one. Somewhere in Colorado, Wyoming, Montana or near about so I can pick it up would be great.

Hi, I am currently rebuilding my 1FZFE and want to use an MLS head gasket. Any issues with using Torque to Yield Head Bolts? Or should I only use ARP studs? Thanks

(REVISITED 2/1/16) My headlight squirter had broken (like most everybodys) so i just threw a buncha parts together to make it work. I bought a radiator reservoir that was universal and mounted it where my old reservoir was. I bought a water pump for windshield squirters and attached it at the...

Hey, I've just blown my head gasket at 260000kms on my petrol 80 series and was wondering what my options are within a small budget. My ideal option would be to drop a diesel into it, but I'm wondering which Diesel engine would be the cheapest to put in? Or should I just fix the head gasket? Or...