front

Was doing an oil change last weekend and noticed that one of the swaybar bushings looks broken and squeezing out of its home. Does that look like the case to you all? Assuming this is a relatively easy job, unbolt swaybar, replace bushings, bolt swaybar back up.

We have 84k miles on our 2006 LC. The dealer says the front CV boots are leaking (I can see grease all over the axles), axle looks good. Local shop says axles are so cheap now, that we should also replace them too (since there MAY be damage). We don't do any off-road driving, if that matters.

Local Pickup only - $50

Looking for oem seatbelts for both front and rear jump seats.

Looking for speakers that will fit the front doors of a 2002 Land Cruiser. Mainly interested in OEM but would consider drop-in, no modification necessary aftermarkets.

This is one of the last bumpers I made at 4x4labes for myself. It is new, hecka straight and smooth, I blended all the welds on the edges and will look killer on your rig, give it a lot of approach angle and protect your investment. Last 2 pics for reference only. $1600 local pickup...

Hi I've torn into a knuckle rebuild on a 84 FJ60. There are grooves on the front axle. They are not too deep (fingernail does not get caught). But I'd love to have someone's opinion about whether I should overdrive (or underdrive?? do I understand that some people do not drive the seal in the...

Hi all - first time posting, hope it can be of some help (searching for this issue turned up nothing). Front end collapsed on my 00 LX this week: no lights, error codes, just suddenly felt like every Land Rover / Navigator on air springs, riding on the bump stops (spine shatteringly poor ride...

In very good shape aside from the dent pictured. End caps were trimmed slightly (and cleanly) to clear 37's. Has triangle brackets and hardware Located in LA but can meet you within reason $100

2020 Land Cruiser OEM brake pads, what's the difference between these P/N's? Front pads P/N: 04465-60280 vs. 04465-60281 Rear pads P/N: 04466-60160 vs. 60161

I am looking for a passenger side front seatlbelt for my 60 series. the one that came out of it is non repairable.

Will buy any and all reasonably priced '98-'02 4.30 front diff carriers for a 100 series.

Looking for either the white plastic washer or the entire rod that attaches to the front heater manual selector as indicated in the attached image. Any info will be much appreciated.

FYI - Documenting what I couldn't exactly find a number for. Just changed the front diff oil after 6 1/2 years and 35k miles of mostly low stress road use. Measured the drain out - right at 4 quarts of nice thick dark gray/green iridescent diff soup. I'd say it was about like a melted...

I'm trying to find out the correct part numbers for the non-power-window armrest pads for the front and rear doors (in grey). Toyodiy lists the wrong numbers - it's showing 74210-89106-13 for both the left and the right side (not possible as they are mirror-image of each other) and the same for...

Is anyone aware of the Toyota spec for which way around a front tailshaft should be fitted? My front shaft was fitted the same as for the rear shaft (slip joint at the transfer case end just like with the rear tailshaft) but it's a part-time 4wd 80 also. Not sure if part-time vs full-time has...

I got these seats in my 1991 hdj81 - Japanese spec 80 series diesel. They are pretty clean although there are a few stains on the passenger seat. the driver seat has electric lumbar and manual adjustable side bolster. Also you can manually adjust the seat angle and the head rest angle. The...

Later FZJ80, straight and solid unlocked axle housing available. Can include knuckles, relay rod and a few other bits and pieces still on the housing. Does not include shafts or birfields. Have third with carrier but without ring and pinion. Ideally can sell this to a local to avoid the...

Pulled from a green 93 (12/1992) FZJ80, but should fit onto trucks up to 1997. In good condition with on bit of rust on the passenger side. Mostly need just need a bit of cleaning. Located in Fort Collins $50 for the pair. Thanks for looking! Rust:

$50 plus shipping. These things are in amazing condition. I bought them new, in packaging, a few months ago. I'm putting sliders on. So, the flaps have to go. Perfect condition!