This was all in a 2001 LX470 without factory navigation. Yours might be slightly different but the concept should be similar. This involves poking around in the factory wiring, so be careful and double check before doing anything destructive, ultimately it's pretty simple and if done right...
Just replaced my TREs on my 80 and noticed my tie rod has a slight crook in it. Is this for differential clearance or is it supposed to be straight? Better to know now so I can easily remove the TREs without a pickle fork.
Thanks in advance!
-Phil
Sold the 100 a few years ago and still have the fsm's. Both are in good used condition but show shelf wear and some grease smudges on the outside pages...
$100 shipped for both
I recently replaced the factory roof rack rails and crossbars with a Front Runner rack system. The old rack and bars are sitting in my garage. It's a complete set with all bolts, brackets, covers, etc. One of the mid-support covers cracked when removed, but it looks to be in good shape...
Anyone has a good set of front 60/62 stock front seats they are looking to unload? Grey is preferred but no big deal if another color.
I'm located in Columbus, Ga and can meet anywhere out to Montgomery Al, and north Atlanta
Evening,
Does anyone know if the factory bumper end caps come painted directly from Toyota? This was the case when i purchased and end cap for an FJ Cruiser several years back. Mine are looking rough on the 80 series I am restoring and I am weighing my options moving forward. Steel bumpers...
I've owned this for the past 13 Years. It started as a stock LX 450 fully loaded with factory lockers. I have found my next project and need to sell this to get it. Price: $19,000 If I don't sell before the other one does then I will keep this. I love this truck and the only reason I would sell...
Hey guys new to the forum and am looking for an 80 series Cruiser or Lx I'm located in AZ. Would travel for the right rig. The right rig would be under 200k with lockers. Thanks for any help!
Selling one pair of Toyota OEM front struts and coils as well as one pair of rear OEM coils as a set. These came off my 2017 200 Land Cruiser after only 1000 miles. Arizona truck straight from Japan. Parts are in perfect condition.
Location: Phoenix, AZ.
$150.00 for everything. Thanks for...
1997 Lexus LX450 w/ Factory Lockers
This vehicle is going for $7,500 and is in Colorado.
New to this site and these vehicles. I'm looking for an lx450 to turn into an expedition vehicle. This one already has the factory lockers. I would be doing a lift and probably 35s next. What do you think...
(see Pix) Factory Tundra Rims - Great condition. Best Offer!
When I first purchased my '08 LC200 it had these factory Tundra rims on it. I opted to do the XD black rims, and have no use for keeping these OEM Tundra rims.
Best offer, I'm south of Denver.
They are in really good shape. See...
Has anyone been able to locate just the rear most portion of the factory 7-pin trailer wiring harness(03-04 models in question)? On both my wife's and my dad's 100s these plugs have become damaged over time. I'd like to just replace them in kind and relocate them to avoid further damage...
Hi ,
- Restored Fj60 Radio 86120-89113 Matsushita brand By national CO.
AM ./ FM
MADE in JAPAN
- 12v volts
- comes with install kit :
-5 5mm x 8mm screws oem toyota
- b+ acc key on pigtail , oem New yazaki connectors
-
- Suminoto speaker wire New oem connector
+
- New ground wire-added...
Hi ,
- Restored Fj40 Radio 86120-35025
Matsushita brand By national CO.
- 12v volts
- comes with install kit :
5 5mm x 8mm screws oem toyota
- b+ acc key on pigtail , oem New yazaki connectors
- Suminoto speaker wire New oem 36 inches W / 3.9mm oem Bullets insulated connectors
- ground wire...
Picked up a 2001 w/ factory nav and after replacing front speakers I'm starting to think the factory JBL amp isn't working 100%. The right channel seems to have more power than left, with the bass being the most obvious difference. I've read you can bypass the factory amp, however, is this...
Looking for a canvas tool bag with handles for the lug wrench and jack handle. Toyota shows 09120-60100 being available for 1972-1980 FJ40s. However, on cruiserparts a search of that number shows a tool pouch like the one in my 80 series (09120-60111). Not sure if that is accurate or not...
Unfortunately I have to part with Greta (an appropriate name for this steadfast beefy cruiser), since my other FJ40 project has gone way over budget and I am getting daily earloads from the wife on why do we need 3 Land Cruisers!
Greta is what I would call a unicorn, one of the rare FZJ80's...