driveshaft

How do I lube up my driveshaft, What type of grease tip do I use to lube up my driveshaft?

Hey all, so thing's i must mention is that when i got from Reverse to Drive and on and off the gas there is quite a noticeable clunk noise, had a play with the front driveshaft and it appears as though there is a fair bit of play within the front diff. Have a video i can hopefully upload of the...

Need a fj40 front driveshaft or the flange and cv joint to go to the transfer case side. Would prefer just the cv and flange cause it could ship USPS priority pretty easy. Sent to zip 80232

The grease plug that fills the end of the front drive shaft is missing from my truck and I'd like to replace it. This is the plug that protects the driveshaft slip joint from water and dirt and also lets you grease the slip joint using the grease zerk. Without the plug, grease pumped into the...

Looking for a complete (including u-joints and yoke flanges) rear drive shaft from a 74-84 FJ40. The yoke flange bolthole measurements are: 60x68.5mm and 11mm bolt hole diameter. I live in Northern California-Sacramento Area. PM if you've got one you're willing to part with along with condition...

Has anyone found Toyota replacement flange studs for the front flange on the rear driveshaft of the 80? I have searched around and haven't found them. The only part numbers I can find are for the bolts and nuts on the axle side flange and a part number 36209a for the front flange assembly but...

In no terms do I classify myself as a mechanic, so excuse me if my analysis sounds silly, but let me get to the point. I recently did a few thousand mile round trip from Michigan to Moab, Utah, in my 1991 FJ80, during the trip after around 300-400 miles of daily travel there would be a noticable...

I have 1968 fj40. I am still a newbie with FJ's but I've done my research and decided on doing a LS swap with a NV4500 5speed swap. I still have a few questions though. What modifications need to be done to drive shafts with the NV4500? I've been told that a split case for the transfer case is...

Looking to get a second rear drive shaft for my SOA 60. My current setup is a SOA fj62 with a bj60 drivetrain ( 3b & h42f transmission ) and hi61 full float axles. I have a h55f waiting to be swapped in but have heard the drive shaft will need to be shortened. Instead on that I would rather chop...