drive

My vacuum actuated front drive works great, but I want to restore the FD knob. Is it a bad idea to remove the cable?

Has anyone used the bell housing adapter from marks I am trying to decide which way to go I have a 72 40 with a smallblock and a three speed I am going to put a 4 speed in it

$15 shipped

Looking for a BJ70 in good shape, don't matter if has good miles in it - cash at hand - Left Side drive - good body & minor rust - If you have one you wanna sell, contact me I'll hear offers.

I am rebuilding a starter from a 67 F Engine and I need the starter drive.

I've had my '97 for 4 years now and just bought a locked '95. I bought it with the intention of swapping a few parts that I needed to replace on the '97 including an ARB front bumper and the locking axles. So here is where I am... I have installed the locker switch, light bulbs in the dash...

Strange question. Does any know how long the driver side front drive shaft is? Or can I just measure from the center of the "pumpkin" to the Birfield to get a good idea? I have to re do my Birfields but will be working in tight quarters on the driver side. It would really suck to get it all...

I'm not sure if this applies to other models, but the the 80 series power seats needed some plastic parts replaced when they wear out. This is the plastic parts that holds the rear of the screw shaft

This last weekend a few friends and I did a little drive up here in Alaska. We went a took what is called the "Bettels snow road" which is only available in the winter. During the summer the only way in is by boat and plane. Then we headed up north and camped just a few miles from Coldfoot...

I've checked FAQ and Search but I still can't figure out all the info about the AHC. I have several questions, but most important, if the AHC fails, can the 100/LX470 keep driving indefinitely or once it fails, you are stuck? How high and low in inches can you adjust?

Hey guys I've been dealing with a worn out clutch and a lot of play in my fj40 for years now. I'm looking to have someone look it over and tell me what it needs in the northwest Georgia area. Anyone have a trusted mechanic in that area? Thanks

I was thinking...mmm bad oil pressure light switch? I was heading off the highway to see my my old house when the light on 3sfe engine was flickering. I turned around drove 1/4 mile stopped at a gas station and perched a quart of oil. The engine does not leak or burn oil. So checked the stick it...

Trying to adapt a 4spd h42 and 2f in a 73 that originally had 1f/3spd. All is done except the front drive actuator shaft doesn't line up with the lever linkage. I read somewhere I need to swap the actuator from a 4spd setup. Any advice? SOR wants more for the parts than I paid for the tranny.

I've been trying to diagnose a drive line "thunk" for the better part of a year - searched and checked the sway bar bushings...no problem. Looked for play in the u-joints...nothing. The "thunk" was pronounced in both forward and reverse after putting the car in gear and getting starting...

New-ish FJ80 owner here. Found a 94 and it's been running like a charm for quite a while. Today while driving I noticed a grinding sound as I stopped at a light. In drive, the truck won't idle forward. I can accelerate and it takes a moment to respond, then jumps forward harshly and cruises for...

Hey guys I’ve got a problem. I used a water based cleaning solvent someone gave me along with parts clean I purchase, to use after solvents' heavy cleaning. Well some of my matchmarks (axle and cage) washed off while cleaning parts. The parts just cleaned in petroleum based solvent still have...

i have a 1975 2F with no oil cooler. Getting it back on the road. The direct drive radiator fan is cracked/brittle, and I could use a new water pump and thermostat. I live in a hot environment. Dreams include power steering and, some day, even a/c (pipe dream). Have a new OEM radiator I'd...

Maybe somebody can point me in the right direction. I was having issues with my driver window working only when it wanted to. So the read the threads and figured id start with a new 'Switchdoctor' main switch. It worked great for maybe a few months and now its back to working when it wants. Im...

There is a strange noise coming from the front of the engine. It looks like the drive belt or fan clutch could be the problem. It acts like it wants to stall almost. I made a video but can't seem to post it. I'll keep trying. I don't think I will drive it. Anybody know how I can post a...