diesel

Recently removed from my 40 and in good shape. I'm hanging on to the hoses. $300

Hi, Looking for a 4x4 tractor with bucket. Can be old and need work prefer diesel. Thanks, Mike

It looks like most people are using various GM 6.5L engines and an NV4500 transfer case. Is this just a cost issue? An R2.8L is a $10K crate motor so not cheap but, it looks like it may be a good match at 161HP and various torque numbers depending on final install specifics. Best Regards, Sid

Looking for 4 exhaust valves for a 1KZ-TE top-end rebuild for my 1994 LC Prado KZJ78. Toyota Part #: 13715-67020. I'm finding it hard to track these down in the US - let me know if anyone has any leads!

I have found myself with too many diesel engines as "spares" and would like to sell this one. 2k plus shipping. It is from a BJ75.

So usually when I turn the key I hear the fuel pump then glow plug timer goes etc etc. About a week ago I cracked open a banjo bolt on the injector hub thing to unlink a hose and forgot to bleed the fuel lines afterwards. It started choaking and struggled to start/stay running without...

Owned by me for over 13 years this is no ordinary ‘80’ and it is only being sold due to ill health. This is NOT JDM. Please note, this car is originally from the UK and is right hand drive, presently it is registered and insured and being used in Spain, to re-register back into the UK would be...

As the title states. Please check to make sure the parts numbers work for your truck. $180+ UPS shipping for the pair. Willing to split up. Thank you. Onur

Cleaning up a bit here and ready to let this 2LT flywheel go to someone who can use it , I had it media blasted a few years ago that is why the finish looks like it does . Ideal for someone wanting to get rid of the hp stealing automatic behind their 2L engine . 100$ plus shipping

Just something that's been on my mind. I can't justify the expense of upgrading to a larger airbox like a radius fab etc(yet), so I've been doing a little research on how else to open it up. Saw mentions of an FJ80/LX450 airbox lid with the larger opening and thought I'd pair it with new 3"...

My HJ45 (1980 long bed pickup) has a 1H engine and a 4 speed manual. Leaks oil. I think it's the gasket of the oil reservoir at the bottom. Anyway, so I have been thinking of whether to try and restore the 1H or do another Toyota diesel. I know I can't turbo the 1H, but trying to determine if...

As mentioned in my presentation I have some issues with the wiring. Many cables cut, some burnt, parts missing etc. So I am rebuilding the thing. Now, I have serious problems finding the correct wiring diagram. I went through the forum and found many, many posts. But somehow none of them suits...

A friend is rebuilding his 1HDT. I put a 2LTE piston rod beside his. Thought it was sort of neat. They both look super beefy. 1HDT left (dirty one), 2LTE right:

Looking for a swapped 60, preferably 350 or cummins, but open to other options. Must run smooth and be mechanically sound with a properly done swap. Minimal/no rust preferred!

Hi If someone has interest in these models, here the chance to get all the Toyota knowledge for them! 7 books, 275$ for all of them + shipment ( heavy package ! )

$30,000.00 CDN, 174000kms, 13BT, 5speed H55f, Cable lockers. Power windows, Power door locks, part time front hubs, A/C to repair. Spare parts: alternator, hubs, calipers, pads, bearings, inner axle shafts.

Selling the following for a friend: 1HZ H55f (no bell housing, to suit rebuild) SOLD flywheel/clutch included. Ct26 turbo SOLD 1HZ was running fine when pulled (troopy) 430km or 460km can’t remember honestly. Engine has the following redone: Valve Shims Injectors Glow plugs BEB Timing belt...

2LTE from 1993 hilux surf with 112k miles. With ECM. Ran great when pulled, truck frame was bad. Automatic shifted great and 4wd worked fine. Excellent fuel mileage. Message me about shipping I have a forklift and can palletize easily. Shipping varies $400-?? Just ask me I am located in...

I have a 3b diesel motor that has sat for 5 years but ran great when parked. Is there a procedure to bring this back and start?

Hi Sourced again some clusters to convert your km/h imported cars into the proper mp/h! Shipping from europe to Conus is around 40$, tracked with EMS. 1. 1HD-FT mp/h manual cluster 330 Eur SOLD 2. 1HD-T? or FT auto cluster 250 eur