block

I recently (a year ago) acquired a complete 3fe engine. I used it for parts to do a 2FE conversion on my 1984 fj60. since I didn't need the block i was going to sell it used, i had no room in my garadge for it so i left it outside on an engine stand and threw a tarp over it. one rainy day the...

EDIT 20-03-2017 - 20:55 PM me if you want the sellers telephone and mail, must go to 3000 euro... : not my add, never seen this damage, I think if you want info mail to or call. I have asked seller for email address and sending options. Seems to be located in the Netherlands, Brunssum: Google...

Came out of my 1996 150k. Had a slight knock. Rotates by hand fine. Never been rebuilt. It's the bottom end only. No oil pans. Crane and pistons are still in it. Price free is someone will use it, it's just sitting here.

I'm currently in the middle of this build on a 66' FJ40: 1966 FJ40 Frame-Off Build (3rd Generation Owner) It's been decided/determined that the original block is too badly corroded to have it machined and rebuilt. I have the crankshaft, connecting rods, camshaft, lifters, etc that I expect to...

Anyone want a 2f bare block? You pay shipping. I'm in Sioux Falls 57105. Going to scrap if nobody wants it.

free bought it in 'working order when pulled'. Could not get it going. Gave up and got a 2F, put the exterior stuff from the 1F on the 2F. My stupidity, was probably only a coil issue. Pan may leak... GONE

Free 1F motor out of a 64' Fj40. Come take it before it goes to scrap. Take the bell housing too. Also have other Fj40 stuff taking up space. Converting to sbc.

Did a pretty complete half way through winter clean up on the interior on my '13 LC. Found a block heater (Kat's 11813) shoved down under the door to the jack. The heater is designed to be placed in a hole (~5/8" diameter by ~4 inches deep) in the block itself...i.e., it's not a water jacket...

I have this here fuse block out of my 67 FJ40. I just rewired my rig so I dont have a need for it anymore. I believe this fits 67-71. $25 shipped in the US.

https://www.barrett-jackson.com/Events/Event/Details/1972-TOYOTA-LAND-CRUISER-SUV-201052

Hello everyone I have a 2F engine block that has been professionally cleaned and fluxed. No issues with it at all, only some light rust gouges in one cylinder that should come out with an overbore. I also have the head from this 2F as well, but it has not been cleaned. I have most accessories...

I was tired of dumping coolant everywhere when I drained my 2F block or radiator...cheap trick follows: I installed an aftermarket radiator in my FJ40 that does not have the extension tube on the radiator drain like the OEM (to carry the coolant past the radiator frame), so it's very messy to...

With the installation of my new 225W spotlights, I began to consider installing an auxiliary fuse box to handle the new load, and to also allow for the installation of future accessories (lockers, floodlight, compressor, etc.). In just a few minutes of researching, I, like so many before me...

I am new to the forum and new to the Landcruiser owner club. I recently bought an 87 fj60 with a leaking headgasket. After sending the head off to be rebuilt, I found out that it is cracked. This has caused me to shift the direction of the build completely. I know that the protocol is to...