belt

Been working on an interior restore of the ‘97 Land Cruiser and after taking as much care as I could saving hardware, taking pics, etc, I have one piece that is lost...2nd row passenger seat belt top anchor. Any advice on how to track all of this down…bolt, spacers, and the clamshell...

Trying to find a good Land Cruiser mechanic to perform timing belt/water pump service on 2005 UZJ100. Any recommendations? Preferably in the South Bay/Harbor City area. Thanks.

Tag says October of 1970 from what I can see. $150 plus the ride.

The bearing on the engine fan of my 2003 LX470 started to make noise, and actually gave out while I was showing it to the mechanic. The mechanic replaced both the COOLING FAN MOUNT SERPENTINE BELT TENSIONER though I don't know if the serpentine belt itself was replaced. I've just called and...

Like the title says, my drivers seat belt will no longer retract on its own. It can still be lifted and kind of fed back in but has gotten worse over the last year. Is there a fix for this or am I going to need to replace the seat belt? Can this still be purchased new if so? Thank you!

Hey all, Can the belt tensioner on a 2011 be replaced without removing the radiator & fan & everything, or is it a more complicated job? Not sure if it is a lot of work, or if I just haven’t figured out the magic moves yet. Thanks! Abe

My right cam does not line up perfectly. It is very close but not right on. Will this be ok?OK? Note the pictures.

Just had my heads redone, replace timing belt and all but now it runs really bad. and all but now it runs really bad. I’ve checked and double checked it’s not a simple jump the tooth… Would love to be able to call right now since I’m trying to get it away from where it’s parked tonight!

Hey guys, a previous owner did a Chevy engine swap with saginaw steering. Lots of the accessory brackets were home brew and not really right, so I want to replace everything and start over. Also on my to-do list is installing a sniper FI kit along with an entire new wiring harness. Apologies...

Hey everyone! Does anyone else have a crank pulley that doesn’t line up exact even though the other 3 marks are lined up? (Oil pump dot and both cams) I checked and rechecked before pulling the pin. Rotated the motor a ton by hand and the 3 marks still line up but the pulley doesn’t show 0...

Hello All- I am in the process of getting a set of fan belts for my '86 FJ60. It's an American market rig with A/C and has been de-smogged using a JimC idler pulley. My rig was built in 'Mar. 1986' per the data plate in the drivers side B pillar. One one hand, I would think the below Toyota...

Or at least do a partial disassembly/inspection. Here's the OEM water pump I bought from the dealer last time. 140k miles on it, had been leaking for awhile with no signs elsewhere. The thermostat housing groove is perfect for an o-ring, 2-034, stays put in the groove with a little goop...

Looking for a good set of front bench seat lap belts for my 71.

Hi all, I just collected Mister Blue, a 2003 105, to daily for a week or two before it goes back in. I parked the truck right after inspection and registration for fear of a timing belt failure. This poor old truck has been out in the UAE sun for a long time and all the rubber has gone bad...

Howdy! Gonna be a tough one, as this is an underway noise. as mentioned, I randomly started getting a squeal/squeak/chirp from the front end. With windows up driving slowly sounds like chirping birds. It only occurs when the vehicle in in motion, gets louder with higher rpm/speed. The sound...

So I had my LX470 at the Lexus dealership for its 300000 klm major service (timing belt etc). On the drive home I stop through a drive through for lunch and roll the window down, the car is making a terrible sound. I roll forward maybe 10 metres to the window and the sound gets loud enough to...

I am trying to chase down a new noise under the hood. Its a sort of "swish" sound that may be either bearing or clutch related on the AC compressor. It cropped up at the end of a long road trip recently. As far as I can tell its coming from the AC compressor pully area. Can I remove the AC Belt...

Hey all, I basically found a 100 series, true 1 owner with perfectly documented maintenance records for the past 20 years for 15k. The timing belt was last replaced 6-2010, 89k miles. I plan to take it to my local guy to replace the timing belt and water pump on Monday. Can I trust this thing...

Hi All, we are new here, My 1998 LC Beulah has busted her timing belt and my mechanic isn't interested in replacing it, he says "it's too old"...! He doesn't know Beulah for the last 15 yrs like I do. It's a love affair really and now both of our hearts are broken. She does have 330K mi. on...

In the process of doing my timing belt, ordered all the genuine bits and I noticed there is a change in the backing plate behind the timing belt Tenensioner. The original one had 2 holes that lined up to the dowels on the timing cover and the new one only has one hole. The new one fits but the...