bearing

Parts guy Shawn down where Cdan used to work, did a great job getting me hooked up with parts. One thing I always liked about Dan (and was willing to spend shipping on) was that I always got the right parts and I didn't have to know everything, unlike at my local dealer. The techie part: I had...

Hi Guys I've just pulled my 2h out of the the 45 and almost ready to drop the 12ht in. I noticed I have a bit of play on the input shaft, both front to back and side to side. Just wondering how much is too much? does it rely on the spigot bearing? Also is the front bearing on the input shaft...

I have a aug 71 fj55 that I am doing transmission work. what I think is the original engine and a 3 speed are in it. I changed the clutch and drove it for a while. Im having to change out the throwout bearing and when I have ordered parts for cruiser vendors and i keep getting a small bearing...

Reassembling my 2F and went to install freshly machined crank tonight and crank hung up on thrust bearing (#3). New crank is from a '79 2F and is .030" over. Old crank was .020" over. Block is 11/75. I bought .030" main bearings from SOR that are for 9/73-10/84. Old thrust bearings (upper...

After pulling my rear axles on my 1974 FJ40 I can not figure out on how to replace the actual bearings. There appears to be a race holding the bearing in place but after doing some research it would appear that this is not a removable race and is built into the axle housing. Also, with the kit...

I have a H55 with 30k miles that decided to eat an Input Shaft Bearing this week...incredibly irritating Given that situation, does anyone recommend a place to change the bearing in the Boston area? I'm in Franklin (close to Gillette stadium) but I commute for work Looking for a place that...

Last night while doing all my Pre-Cruise Moab checks on my truck I noticed a very slight amount of up/down movement at the pinion flange on my front diff. The diff has 4.88 Nitro gears and install kits from @justdifferentials that were installed just last summer, so I'm a little surprised to...

LCers, Getting close to putting the motor back in. Been traveling for the last year and been limited to the amount of time I can devote to my LC. Clutch is in and of course used the alignment tool,and the pressure plate is oriented correctly to the flywheel. The Pilot bearing is sort of...

Does anyone know the size/diameter of the (3) ball bearings that are used in the base of the side view mirrors? Mine came apart while driving and all (3) ball bearings went with it. I want to avoid taking apart my passenger side mirror to find out what size they are. If anyone knows the size...