I need to replace caster correction bushings with stock bushings.
I have a 20 ton press and experience with this kind of work. What are people using for press bushings? I have a minimal set of random bits of steel and sockets, but nothing purpose made.
I'll probably use this once and put it on...
I m in the process of replacing the Pitman Arm & the Drag Link of my BJ 40.
I am unable to remove the 32 mm Nut that holds the Arm. Is it in the normal clockwise thread OR Counter clockwise thread ?
It is so tight & what is the best way to remove it. Not possible to heat due to possible...
I have a rear wiper arm for an 80 series for sale. The part # says it's 91-92 but I can confirm it'll fit 91-97. I bought it new 5 years ago so it's lightly used but still looks new and puts plenty of pressure on wiper/rear window. $40 OBO. Located in Salt Lake City, UT.
Hey all, Had a half successful half frustrating day today while trying to replace my stock upper control arms with SPC arms. I started on the passenger side, I used a 5 ton puller which wouldn't make the ball joint budge, then I can't tell you how many times I hit the damn ball joint with my...
Any one know the year or the part numbers of the 4runner wiper arms to upgrade my FJ60 wiper arms?
I did this up grade 10 years ago and my local Toyota dealership can't find what I ordered back then. All I
know is this was the best upgrade along with a new windshield and windshield gasket.
I...
I went out with my early center arm rebuild kit that I got from @cruiseroutfit and ran into a couple of issues.
Firstly, I failed to notice the mangled threads on the top of the center shaft and promptly stripped out my M16 castle nut. For this, I just need to find another nut and re-cut the...
I did a disc swap on my '73 FJ40 and I picked up a couple knuckle arms at a swap meet. It wasn't until I got the knuckle arms all cleaned up and painted that I noticed that they had different hole diameters for the tie rid ends. I guess there are different TRE's with large and small diameter...
Hi,
I have a 1965 FJ40 that I daily drive. Winter has come here in northern Wyoming and the stock wiper blades aren't great. Does anyone know of a part number for a wiper arm that accepts modern J Hook wiper blades that fit on to the early FJ40 wiper motors?
Thanks!!
Sheldon
Just finished up pressing in the OME radius arm bushing that came in my 2.5 lift. Not too terrible, worst part was getting out the old bushings that were cemented in after 320k miles. The issue that I’m running into now is I’m a good inch or so off line to try and get the bolt holes to line up...