Looking for FJ40 or 60 spring over housings or axles. Thinking about changing some things up on the 71. Bolt in would be awesome, but if I can’t find something I’ll mess with the housings under it.
Gary, I do still have the 99 4Runner, but...
haha - I want the Supercharger to go with it too @Cornhusker! other then making the cuts right the first time - the scoop and vents really dropped engine temps - scanguage showed about 12 degrees.
The new DD is mostly built out, have it in VA and hoping to take it to Quebec and Maine early next month to wheel it.
Gears are stock - with 35's in the flatlands I've never felt the need to regear an 80.
I've got some pics on my drive at the...
I just have to buy this truck without a hood and let him sell you the hood on it.
(I just happen to have a spare hood sitting in my garage).
PM has been sent.
:D
John
Ok, I’m gonna keep going with my reseal job here. Maybe it helps somebody down the road. Tagging @Hokie LX since he’s doing this right now too. Maybe we can compare notes.
I talked to Hokie and he’s got engravings on the parts above as well so...
I'm preparing to sell my 2021 200 Series as I am going all in on my FJ62 and am keeping my 1969 40 as well.
Trying to figure out how to price this beast, thought I'd get y'alls opinion. To be clear, I can't part with it until at least May, so...
The snowstorm was a dud so the truck has been sitting for a week or so. I had to head west for work so instead of drvining the 2011 Chevy Pimpala I took the 80 out on the highway. Outside of a little wind from the North, the drive was great!
No idea! I haven’t measured it but I get a bit more miles per tank than I did before with the 3fe. BUT I can actually pass cars and not slow down going up hills!
We did quite a bit of work on this cruiser and I’ve driven it extensively. It’s been an ABSOLUTE PLEASURE working with the owner/seller. He wanted “everything done right and do not cut any corners”.
This 80 runs and drives extremely well. I...
Reinforcing the idea that I have automotive ADHD, I’m going to sell my 91 FJ80 and move on to something else. I know it’s a bit of a cliché, but this really was a ‘no expense spared’ build and I have zero expectations of getting all my money out...
Hey Eric, I am sorry I have not updated the listing here to be more accurate
Cometic MLS head gasket, APR head studs, all new OEM main and rod bearings, rings, valve guides, 3 angle valve job, head and block decked, all new OEM gaskets, valves...
Pete,
Pete is the painter. He's been around here for 30-40 years as a tech and painter. Great work. He uses a Sata for base and Iwata for clear. Not too bad for old school shop painting with a wet floor and no booth. Beats some of the best booth...