I’ve waited long enough and would finally like to purchase my dream car......a BJ-42!!! Please let me know what you have, and we’ll go from there. Not looking for a pristine one, but a project truck! Just as long as its not all rust 🤢. I’m located in Massachusetts but willing...
I’ve waited long enough and would finally like to purchase my dream car......a BJ-42!!! Please let me know what you have, and we’ll go from there. Not looking for a pristine one, I dont mind doing work on it. Just as long as its not all rust 🤢. I’m located in Massachusetts but...
Good morning everyone,
I wasn’t sure which section to post this in so I went for the one that gave me the warmest feeling, the Diesel section. 🤤
So basically i’m writing this post because I just recently met an individual who’s selling two (2) 1981 & 1982 BJ-42’s imported from Canada back in...
ManaFre smog pump eliminator pulley. Run for a short time (500 miles) before getting swapped out for a second alternator.
$165 shipped in the lower 48.
Same one as here:
FJ40 FJ60 Air Pump Eliminator Air Pump Idler Pulley for 2F Engines 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987 SKU...
I have a 71 FJ40. Is there an inexpensive master cylinder from another year or model? My truck was made in June. Pictures of other years look pretty similar. Will the later ones bolt up?
I’m about to do a front disk swap to replace the drums.
I took both my stock 2f long blocks to be rebuilt and one had a cracked block and was otherwise rebuildable I'll be selling the internals of that one.
cruiser corps wants 700 for a used crank, I don't have overhead so make me an offer. start at 500?
I should have a usable cam as well 100?, one...
4 BFG Mud Terrain KM2 38x14.50/R17 Tires $600!
I have 2 sets of 4 (8 tires total) used BF Goodrich KM2 38x14.50/R17 off road tires for sale. Mfg date codes are 2010 and 2011. New tread depth was 21/32". These tires have at least 15/32" tread left (one is brand new, never used)...
I am currently putting a 1975 2f out of a 55 into my 1971 40 and have ran into the problem of my throttle linkage. I honestly can't rap my head around how I am gonna line anything up and connect it as nothing at the moment is anywhere near lined up. Any help is appreciated!
Dropping the tranny/tc, what is the best way to support the rear of the engine so i can safely remove the propeller bracket on the tc?
Using the windowsill 4x4 method
Thanks for any wisdom you can provide...
'76 - 40
'78 - Chevy 350 v8