3fe

Guys, I bought another head for my 88 fj62 and don't need it. It came from a running engine with good compression. I took it to the machine shop I always used and had them recondition it. It has new valves, new springs, and new seals. It has been pressure tested and magnafluxed. It is...

Looking for opinion or testimonial on a 3fe owner putting the manafre replacement long range fuel tank in their rig. I called manafre and they said it's a-ok, but the installation instructions says it's for 92-97s. When asked they said they weren't sure but no one ever complained, but didn't...

SoCal from an FJ80 1991 3FE engine block without head Exhaust System - Complete or Parts Coil Sensors ECU Alternator (not the big one) Starter All Brackets PS pump (pulley has been sold) Air Conditioning System or parts, compressore, lines, etc (R12 system) Radiator Water Pump ETC...

I recently sold my fj60 and purchased a project 1991 fj80. It ran and drove but it had a hard time starting and its exhaust had a rich fuel mixture. It seemed like it had a hard time accelerating but I am unfamiliar with the 80. After its first 20 mile drive it wouldn't start again. I took a...

I recently had the 80 partially tore apart, running coax down the passenger side, for a CB install. As often happens when I undertake any project on the Cruiser, I end up following what I call rabbit trails; one project leads me to investigate something different, that may lead to something...

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

91 FJ80 3FE ECM burned diode D105

Shipping available for most parts, but not for fenders, hood, doors etc. Grille and bumper apron (panel below grille sold). All other body panels ( hood, fenders, doors, tailhatch,tailgate, flares, bumpers in VERY Good condition with clearcoat peel, but NO RUST Seats are manual and cloth and...

hey everyone, yes I'm making another thread on this topic. I've read all through the previous threads about this problem but here's my problem Efi fuse blows only under load, if it's in park or neutral I can rev the heck out of it but as soon as I drive it and it goes above 2k the efi fuse...

chase's fj80 by yotaboy posted Nov 22, 2017 at 11:22 PMwell i'm a 80 series owner again for my 3rd time as of yesterday!!! been out of the game for a few years. here's the details. 1991 Land Cruiser 3fe 187,000 miles cloth seats sunroof I've been seeing it for a while sitting in the field near...

what up mud... hoping someone can help me solve an issue that I've been working on for about a month now. I'll start by disclosing the symptoms I'm having right now and go on with further details. So long story short, my FJ80 was starting to burn coolant and running rough, so I went ahead and...

SoCal Good condition, no leaks, good seals, DOES NOT FIT 93-97 $125 including shipping within USA. Pulley is not available.

91 fj80 3FE 269K and going Having trouble finding manifolds or headers that bolt on (after market). Not sure if they even exist. Found some headers with down pipe from cxracing, but not for 3FE... at this point I’d even entertain a used setup. Found front and rear manifold on eBay and...