24 volts

As detailed in another thread, I am likely going to be rebuilding my 2.8 diesel. Because the 3L and 5L engines (5L with mech injection) are incredibly similar, I have considering swapping in a low mileage 5L. Finding one has so far proved difficult. I don't know of anyone that imports them...

Good evening all I’m completely stumped here. On my HZJ76, which I’ve had basically since “new” (full story here: Ali, the 2008 HZJ76 - https://forum.ih8mud.com/threads/ali-the-2008-hzj76.1272844/), quite suddenly I’m experiencing severe smoking and hesitation. The engine has 16,000km on the...

Dear all, gathering parts for my future BJ45 resto and purchased a good 2H engine (300,000 km/190,000 miles). Got it from a German friend who swapped it in his 1985 HJ60 for a 12H-T. Now I found here in Greece the relic/hulk of another German 1985 HJ60, sitting in the mountains since five years...

Just yesterday driving into work.... 700 k km's in 31 years of life since the vehicle was made by Toyota. The t-belt warning light came on as expected to remind me it needs to be done. Is there a contact on the left most number wheel of the odometer that activates the light? I'm aware of the...

Has anyone installed Eaton Elockers on a 24 volt cruiser? Did you need to run a buck converter to bring the voltage down to 12, or does the locker engage/disengage with 24 volts?

Hey all. I've been recently looking into modifying the stock governors for our rotary injection pumps. It used to be popular with the 1.6TD Volkswagen guys, however the same tricks can easily be transfered over to our pumps. There are two styles of governors. The pull type all speed governor...

I was looking at my 1hdt manifold to plan out my egt gauge install and looked at a ground wire on my valve cover and noticed the ground going to my turbo. I dug around and found this sort or wrapped around the turbo, and it has a male/female plug that goes to a ground. What is it? Tried...

This is on the side of my 3Bii block. Original engine, vehicle construction date 07/1989: Now I read this as '9' meaning 1989, and '6' meaning June. or could it be Week 6 of 1989? No idea what UB means! Wondering if anyone knows more or can correct me? Before anyone chimes in with it, no...

Hey I just bought a 2lt manifold for my early style engine. Obviously I don't need it but I just had a thought. What if I used it as an emergency shutoff in the case of a runaway condition? I could hook it up to a choke style knob in the dash and pull it if I need to use it. Could even use it...

So usually when I turn the key I hear the fuel pump then glow plug timer goes etc etc. About a week ago I cracked open a banjo bolt on the injector hub thing to unlink a hose and forgot to bleed the fuel lines afterwards. It started choaking and struggled to start/stay running without...

So, I am dreaming of a 1HD-FT swap in my FJ40 (would stretch it 10"). I'd be running an H55F behind the 1HD-FE through for what I am thinking here I might see if there is a way to run an NV4500 or TR4050 instead. Seeing the prices of used 1HD-FT's, it seems that I could get a Cummins 2.8 new in...

Whilst working on my 1994 HDJ80 connecting a new accessory to an additional fuse I fitted some years ago, I noticed the flasher unit looked a little out of shape. Removing the unit I found the casing had a hole in it! Given the area in the right hand footwell is full of wiring and other relays...

So i got my thermostat from Cruiser Outfitters. It’s a crossover 3B, 13BT, 2H, 12HT My memory is a bit foggy, I remember in past the rubber split gasket used to come with the thermostats. Cruiser Outfitters website they are not needed. So the two I received don’t have the rubber gaskets. But...

Rig: 93 HDJ81, 37" tires, Gturbo green wheel, pdi intercooler, Manta 3" exhaust, WAT extreme valve body, 3.11 low gears and 10% underdrive in xfer case. Rig is used offroad but 3 to 7 hr highway drives (usually in mountains) are not uncommon to reach fun destinations. Question: What diff gear...