@Green Bean Thank you for your nice words. I really don’t mind a project like this but…my preference is to plan for it ahead of time, be fully stocked on supplies and dive in. Ran out this morning and picked up over $160.00 in brass fittings. The pressure tank was near $500 and The T for the bottom was $40.00. Since I have ZERO knowledge about water velocity and pressure, I used the recommended T at 1 1/4” or I could have made it in copper. I have a bunch of copper fittings over the years (40) from projects all over the house. I really like water pressure. That old bladder tank was about 24 years old and over the week started losing pressure and volume. Had no choice today as it was less than a stream at the sinks and showers
By the way, the Sniper is running great. I still cannot get the IAC to stay a 2-12%. It always returns to 0. On the other hand, starting it brings a smile to my face. Turn the key, wait 5 seconds for fuel pressure and the computer boot-up then engage the starter….it starts instantly. By comparison…if it sat for a few weeks, starting was full choke, crank for 10-15 seconds 4 different times and by the 4th try it would cough and start . Here’s a tidbit : of the 25’ roll of 3/8 fuel line, there’s about 2’ left. Had to trash a few. Some times the proper bending tool would kink the bend or the 37 degree flare tool would smash the edge of the flare when I forgot to lube it before flaring
