Thinking about relocating A/C ....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 18, 2014
Threads
45
Messages
312
Location
Alabama
component (not sure what it's called) that hangs down in front of the radiator before building a low profile front bumper. I'm sure it's been done before so any advice would be appreciated.
 
Called the AC drier. Google it. Many have done it. Some simply turn it installed. Carefully.
 
Yes. So long side is horizontal. Google it first. Cannot remember which way to turn. Left or right.
 
These can be massaged upwad over an inch by bending the hard lines carfully. They can also be replaced with shorter units from other Toyotas and they work just fine. Search is your friend.
 
Mine is rotated counter clockwise and pushed slightly towards the center of my rig, to fit inside my bumper:

 
I just bent mine up. Been working fine since. Just takes some time, the lines are fragile. @auttiman

A8D5E67D-2C2B-46F4-9045-3D78CEE28EE1.webp
 
Moving the receiver/drier up or replacing it with a shorter unit are both good solutions. I wouldn't turn it horizontally...as this defeats/encumbers the purpose of the unit.
 
Or one could just buy a 93 that comes that way from the factory.

I spent some time looking at diagrams and I think that may have ended in 5/93. I'm not at all sure yet, but that's the cutoff date for several AC part number changes. Then again, maybe that's the end of the 93 production run?
 
Prolly needs it's own thread, but any of you ever remove the egr system? We don't have emissions testing where I am and I'm thinking seriously about removing all that crap.

TIA
 
Prolly needs it's own thread, but any of you ever remove the egr system? We don't have emissions testing where I am and I'm thinking seriously about removing all that crap.

TIA

Search should offer multiple threads on the subject. I’m kinda lazy so I would just place a thin piece of sheet metal between the valve body and the intake to stop all exhaust from passing thru the system and going into the intake airway.
 
I spent some time looking at diagrams and I think that may have ended in 5/93. I'm not at all sure yet, but that's the cutoff date for several AC part number changes. Then again, maybe that's the end of the 93 production run?
You are probably correct. Mine is an early 93 and was R-12 until I converted it. Sure is nice having the dryer up out of the way.
 
I'd like to know if there is a reason the dryer was placed low on the later rigs. They already had the upper position worked out, so there must be a good reason.
 
Back
Top Bottom