TEQ Grille Badges

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

It looks great! Very happy with it. Thanks again, Mark

image.webp
 
Last edited:
ONE ORANGE BADGE LEFT - that's it!
 
Chris8760 said:
Had to get two extended screws and stole a plate out of a threaded c-clamp. Worked perfectly. Pics attached- bought them at HD.
Click to expand...

awww sweet, here's the pics. So did you have to cut the head off the screws before you used them? Basically making your own threaded rod.
HD didn't have threaded rod so small but I'm sure the local hobby shop does.
 
As of 4/23/2014 I am SOLD OUT... thank you for your support.....
 
Didnt have to cut the screw heads. The screws were just a bit longer than I needed so I used a small nut on each to clamp down on the bracket- you'll see them if you look closely at the pic. That's all of $5 or $6 or so of parts from the screw/nail aisle at HD. It's solid- badge isn't going anywhere for a while.
 
No plans... unless there are 20 or so folks ready to go...
 
Well maybe I should take preorders again to see if there is enough interest. Give me a while to contact the supplier to get current pricing...
 
I might get this started again in a couple of weeks....
 
It'll be between $55 and $60 shipped unless prices are really up at my supplier...
 
You must log in or register to reply here.

Share this page

Back
Top Bottom