Shackle Angle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 19, 2006
Threads
126
Messages
773
Can someone explain what shackle angle is all about. I've searched and can't seem to find anything.

Thanks.
 
Shackle angle has a minor effect on overall spring rate that varies with the arc of the spring. With a stock nearly flat spring, a 45 degree shackle actually decreases the spring rate on compression. My opinion is that the effect on spring rate or ride quality is so small that you can forget it.

Shackle angle has a lot to do with articulation and this is the major consideration. If your shackle is too short and has too little "swing" you can severly limit your axle droop. If the shackle inverts or hits the frame on compression, then it will ride really rough.
 
Can anyone tell me why I have two different angles going on here?
MVC-389F.webp
 
Because the springs are different lengths......
Why?
either they have different rates or
they are loaded differently or
??
There are other reasons, but if you rig is maintaind and the bushings are in good condition and the hangers are in there stock location, it is probably due to one of the above reasons.
PMK
 
PabloCruise said:
Can anyone tell me why I have two different angles going on here?


The engine is shifted to the drivers side a few inches.
Thus there is more weight on the drives side, making the truck lean a bit to the drivers side...

It's a 'Cruiser thing.
Just accept it...
:D

Edit:
Mines even MORE pronounced than that!
 
PabloCruise said:
Can anyone tell me why I have two different angles going on here?[/QUOTE

Same thing here! I agree with tigerstripe40, It's the 'cruiser leen thing :D
 
camcruiser13 said:
maybe one of those is the front spring?


That would be the first thing I would check. Count leaves and measure length.
 
See, cruiser lean :)
 
PabloCruise said:
Would this DS rear shackle "issue" be contributing to my front shackle angles?

Oh those were front shackles, eh? So your cruiser lean is 'normal'.

It looks to me like the frame mount for that shackle is twisted. The spring looks ok.

What happened to the bumper? Did that shackle take a hit at the same time?
 
so whats the optimum angle to have ya shackles at then? i'm new to the game and about to do suspension mods so am keen to hear all..

am interested in anti inversions up front.. :D

pinhead- witha 50mm spring lift, is 45 degrees still the best angle?

sorry, dont want to hi-jack thread...
 
STOP high jacking my thread :flipoff2: .

Okay, what are the best shims to purchase for the HFS 4" Lift?
 
Back
Top Bottom