Problems Balancing Tires

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 11, 2019
Threads
155
Messages
1,504
Location
NJ
I currently have BFG K02 295/75/R16 installed.
Tried to get them balanced at a couple different shops and all could not balance. Upwards of 17oz needed.
Decided to replace tires with a smaller size same tire. 285/75/R16. Same result.
They looked at the rim and said it was straight and balanced.
Does anyone else have issues balancing this size? It’s gets loud at 60/65mph.
Any suggestions?

6815E3CB-87A6-43A6-A439-0777869A255B.webp
517F2493-0803-4D3F-864F-E0E5ECE94F09.webp
 
Some more information is needed to get a better picture of your situation. Are all four assemblies on the high side regarding total number of weights? Ideally you want to be at 140g or less per plane on each assembly but of course there is wiggle room.

Did the shop perform rim runout check on each bare rim? Did you ask them to try doing a ride match to make sure the low point of the wheel and the high point of the tire are aligned?

Is the guy doing dual balance or static balance?
 
They did not do any run out checks. They spun the rim up and did not visually notice anything out of norm.
I’ve located a facility that has a road force machine and will see what they can do next week.
Anyone in NJ area need brand new 285/75/R16 BFG K02? Paid $900 for them.
 
It is tough to get tire manufacturers to admit any flaws but those tires could be from a bad batch. Does the build week match on all four?
 
I'd try a new shop. That shop may not have the right adapters for the wheel (from my experience).

I have 315 Patagonia's on mine and they balanced out with less than 3oz on each.
 
Odds are you will have to balance with internal beads... I believe it has to do with the "tire" shop not having the proper Adapter for the tire machine for a "toyota" rim. - I think its called a flange plate adapter (don't remember off the top of my head)

Place I took mine too tried all sorts of weights and could not get my "new" tires to balance properly. Internal beads did the trick for whatever reason.
 
Patch balancing or tire beads are for tires that need correcting. If was the OP, I would demand a return and get some other tires.
 
I would definitely be trying a different shop
 
I am going to try a truck shop tomorrow. If that fails, I have another shop that is confident they can balance them. Though they have no availability till next week.
Had the same issue with my ko2 33s. PO tried to correct with beads, still out of balance. I took it to a different, reputable shop who removed the beads and did a proper road force balance, the problem was cured.
 
I like beads when you use enough it is pretty easy

There is no reason someone should need beads to balance new BFG K02 295/75/R16
 
Sounds very frustrating. So sorry.

I disdain wheel shake so much I even roadforce every rotation. I’ve had gl with my 16x10 cheap steelies on ko2 315s. Smooth.
 
There is no reason someone should need beads to balance new BFG K02 295/75/R16

Ok I just took advice from a tire guy, who said some of the larger tires have issues and beads are the best BTW all big rigs use beads and have no issues ;)
 
Back
Top Bottom