New Wipe Wash switch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 4, 2018
Threads
39
Messages
155
Location
Austin, Texas
Hey all,

I'm looking for an OEM "Wipe Wash" switch for the dash. Mine is broken and only has the pull function, turning it does not activate the wipe spray. I know this is picky but I'd like like to find the OEM one that actually says "WIPE WASH" and not the wiper icon on the knob. Does anyone know who sells this? Cool Cruisers does not have it and is claiming the wiper icon one is OEM. Any advice?
 
I have a box full of those switches in Burbank. What year are you looking for?
 
Redlinelandcruisers sell some that may have what you are looking for. Here are a couple screen shots. They’re located in Colorado Springs, Colorado....

F247CEB8-4B35-4301-A0F0-F8669FDC5AE3.webp
95799492-D973-4E2E-9418-7A803E520004.webp


CHECK ‘EM OUT !! 👍
 
When you say turning the knob doesn’t activate the washer, have you tried to repair it? Can you describe what it does/doesn’t do?
 
Turning the knob on a FJ40 wiper switch GROUNDS the separate Blue/Yellow wire that plugs into the male tab on the wiper switch. That wire runs to the wiper washer motor. [The other wire (the Blue wire) at the wiper washer motor goes to a fused +12V wire straight from the fuse block.]

Therefore the wiper switch frame MUST be grounded properly in order for the washer motor switch to work. Since the grounding of the wiper switch frame occurs through contact with the dash metal, if you have a freshly painted dash, the switch frame may not be grounding properly. You can add a separate ground wire to the wiper switch frame, or scrape a bit of paint to bare metal to allow it to ground to the dash.

So before you buy a new switch you should first clean the contacts for the washer motor switch, then ensure it is properly grounded to the dash. To test it, use a clip lead clipped to the wiper switch frame then to a known good ground like a bolt through the firewall.
 
When you say turning the knob doesn’t activate the washer, have you tried to repair it? Can you describe what it does/doesn’t do?

@Coolerman

I tried repairing it, yes. However now the knob isn't "firm" or rigid in place against the dash anymore and can be wiggled side to side unlike the other knobs. It wasn't this way prior to trying to fix it so I assume I broke it.
 
N0... That tab is where the washer motor Blue/Yellow wire attaches.

White/Black is the color Toyota uses for ground wires. Don't be confused by the two white/black wires that are in the actual wiper switch connector. Those ARE ground wires but are for the grounding the the wiper motor for low and high speeds, and for the park circuit ground. Those ground wires do NOT ground the wiper switch frame.
 
If the switch is loose in the hole in the dash panel, the nut may need to be tightened. There should be two holes in the nut. I use a snap ring plier, or needle nose pliers to tighten it in. You’ll need to remove the knob. Loosen the Phillips head set screw, then unscrew the knob out.
2387AA34-D652-478F-A543-5EF9ED6EEE57.webp
 
I need a switch for a 76. The ones I see that say OEM online have the icon instead of text. The solution from Redline that was posted looks pretty good unless something else is better.

I'll see about tightening the knob first and making sure it's grounded properly.
 
Back
Top Bottom