Jb weld tranfer case?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

cruiserjunktion

Cruiserjunktion@gmail.com
GOLD Star
Joined
May 19, 2005
Threads
733
Messages
6,638
Location
North Florida
Jb weld crack cracked tranfer case?

How to repair ?

While the LC is in pieces, I want to repair this correctly. (DIRTFT)

Would using jb be similar to using a band aid for a broken leg?

I plan on using the 4 wheel drive system for mild trail use.

Is this a commen area for breakage? Does that scuff in the pic look new to you

too? Could this be from dropping on the ground? Oops....... help
fj40 tlc 157.webp
fj40 tlc 158.webp
fj40 tlc 156.webp
 
Last edited:
As good as JB is, that looks a bit more than JB can handle.
 
Three options

Drill a hole at the end of the crack , groove out the crack and have someone weld the whole thing back right then grind flat.

You can JB weld and with light use very light use you might get by.

Replace the case only. You already have it somewhat apart do it right.

Problem with crack. It's at a critical point. There is a reason it cracked. From hard front driveline use or a blow from a rock to the nose cone or driveshaft.

From the looks of the oil and sludge I would yank it and find a new case. You are this far you might get by but you might be doing this all over again.
 
Last edited:
Trollhole said:
Three options

Drill a hole at the end of the crack , groove out the crack and have someone weld the whole thing back right then grind flat.

You can JB weld and with light use very light use you might get by.

Replace the case. You already have it somewhat apart do it right.

Problem with crack. It's at a critical point. There is a reason it cracked. From hard front driveline use or a blow from a rock to the nose cone or driveshaft.

From the looks of the oil and sludge I would yank it and find a new case. You are this far you might get by but you might be doing this all over again.

Option four, find someone who just did an Orion case upgrade. They will have an empty case laying around looking for a home.
 
my brother in law did this to his &eep transmission. he used JB on it, and it did not hold. we welded it with a welder for aluminum. it has worked fine ever since. it will need grooved out and filled in. it is pretty easy to do not use JB on it, and then decide to weld on it. that stuff will not come off very well, and you will have inclusions in your weld. or you can replace the casing too. my dad did that on his 40. just my 2 cents.
 
You should be able to get a used housing for about $50 and move the guts. Put an ad in the wanted section. That's how you would do it right.
 
Back
Top Bottom