Gas Tank

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 20, 2006
Threads
139
Messages
4,041
Location
Pequot Lakes MN
I pulled my gas tank tonight... My truck has been sitting for 9 years... so you can guess what the gas was like on the bottom of the tank... the tank itself is in good condition, very little rust. so what is the best way to clean up the inside.

so far I used water to wash it out as well as I could I will have plenty of time for it to dry out, then I poured about 3 gallons of fresh gas in the tank.... I am letting it sit for a few days, then I will dump that out... I figure I would do that at least 2-3 times...

what do you think..

A.P.
 
apeterson said:
My truck has been sitting for 9 years...

what do you think..

I think since you took the time to take it out, you should get it boiled out properly, unless you see pretty metal when looking down there with a flash light.
 
how do I do that? I have never heard of that.... no I do not see pretty metal... I see gunk!
 
Get some carb cleaner, put in the tank, swish around every hour so so and let it soak for 24 hours. Dump that out, pour in some dishwashing liquid, slosh that around for a bit , dump that out. Inspect tank. If clean and you don't want to seal it , then fill with gas and use it. If you do want to seal it then get a seal kit from a company like EastWood Company and follow the directions.

Your carb could probably use a good cleaning not to mention the fuel pump and lines. Post up your success or questions and post up some pics!
 
I did not take off the sending unit.... Did I wreck that now? Took the plug out when I was running gas and water though... it is back in now.. I did use up all the carb dip that I had left after I got done rebuilding my carb....
 
I am for taking it to a radiator shop. An alternative is to get a kit from someone like POR to clean and then seal the tank. The radiator shop did mine for $75 total and the did not "boil it out" or tank it, they used steam.
If you do it yourself, which a lot of guys have, it does not hurt to throw a piece of medium sized chain in the tank to help remove rust scale as you shake and gyrate the tank. Mine is 41 years old and does not leak.

GL

Ed
 
PabloCruise said:
Take it to yer local radiator shop...

x3

search these forums, I have a write up about taking it to the radi shop - plus the topic has been covered many time.

DIYS is a pain in the ass in for this project as it can be just as expensive for materials and time, no guarente (like a shop will give), and you need to dispose of the nasty ass hazards crap that comes out of the tank... take it to a radi shop.. 2 day job
 
Yes the radiator shop is a good choice, I had mine cooked, cleaned and epoxy coated for 60 bucks. That was probably cheaper than I could buy the stuff to do it myself, got the radiator thrown in and done for 60 bucks as well, cheap insurance for the trail. BUT
I have used the chain method that works well for tanks that don't have alot of baffling. Be prepared to shake and shake and shake.
I also used to use LYE, that stuff you buy for your drains. I'd clean up old RR lanterns with it by dropping them in a 5 gallon bucket and adding two cans of lye, leave em sit for several days depending on how rusty they were and them wire brush them.
If I wanted to do it the cheap and easy way DIY, I'd clean it out with water, pull the plug and sending unit, then drop in one can of lye (after putting the plugback in) then let it sit for a day or so, drain it, drop in a 18-24" peice of chain and rattle the hell out of it. Drain it then add some epoxy gas tank sealer. Foe all that trouble I'd take it to the radiator shop or buy a new one from toyota. Make sure they give you a TLCA discount, that should be close to 20% off or wholesale price. Most decent dealers will do that. Good Luck
 
I just called our local radiator shop and he said he does not do gas tanks any more and does not know anyone that does it... so I guess I will try to clean it up as well as I can.... Then decide if I can use it again....

how do I get the chain back out of there???
 
I've steamcleaned tanks in the past. Took it to a steamcleaning place and paid some guy $20 to clean it out. Took about 15 minutes too. Not sure how much crud was cleaned out, but it never gave me anymore problems.
 
well used a friends pressure washer last night.... worked great... got lots of crud out of there.... going to use a chain tonight to see if I can get some more..
 
Back
Top Bottom