Clutch-ing Offroad

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

you might wanna decide how you want to use yur 40... will it be a daily driver?
will it be used hard off road? Since you claim to be a newbie... If your gonna use it to play in the rocks...you might want you first upgrade to be some kind of lower gears, I wheeled for nerly 20 years before going lower and now that I have, I would have a long time ago...maybe even before lockers.
either way keep your foot OFF the clutch. An overall good crawl ratio is around
80 to 1, Youll be amazed how much easier to drive it will be. one more thing "side stepping" the clutch is never a good idea on the the trail....
it can put you in some really dangerous positions.
just my .02
Dave
 
nuclearlemon said:
if you stall, a lot of times, you just bump the starter and the torque of the engine will catch...give it a tap of the gas and its running and pulling you again...you never touch the clutch.
Plus, if you're stalled on a steep decline, bump-starting with the clutch engaged will allow you to get rolling again without losing your engine compression braking and end up free-wheeling down a steep hill. (Natural reaction to that is usually jumping on the brakes . . . . which makes it even worse.)

Locked-up brakes + loose terrain = no steering or braking control.
Enjoy your ride on a 4k pound out of control bobsled. :eek: :eek:
 
alkaline747trio said:
Haven't had much time behind the wheel of a stick; so, any of you guys know where some good readin (pretty bored on my Christmas break right about now) on clutch driving techniques can be found?


what with the words and sentences and stuff?


it's more of a do or do not kind of thing.
 
Sometimes it is easier to read stuff that is written with propper grammar, that and I was in a groove while working on a damn research paper.

All this about when to double clutch, and bump-starting is more fun to read then Kennedy being shot. Anything I can read up on...
 
alkaline747trio said:
Sometimes it is easier to read stuff that is written with propper grammar, that and I was in a groove while working on a damn research paper.

All this about when to double clutch, and bump-starting is more fun to read then Kennedy being shot. Anything I can read up on...


funny, i would take the history book over the tech manual any day.
 
chuglife said:
yes, but then you might have too much speed for the trail ahead.


side stepping the clutch is exactly what it sounds like, put the clutch to the floor and then slip your foot off the side (engaging it really quickly)
No such thing..


Side stepping the clutch involves the gas/brake/clutch all at once.

Basically you rev the piss out of your motor while the clutch and brake are depressed, then you release the brake and clutch at the same time you floor the gas..


It is a lot of fun ;)
 
get out and practice it... geez, it's like people that ask for handbooks on sex... you have more fun figuring out as you go along.
 
HAHA!!! So true, so true... Go out and play! (With your rig, that is:grinpimp:)
 
Hi All:

"GaCruisin" your rig has gearing too high, and/or the idle level of the engine is set too high.

You should be able to idle the engine in gear, and just "chug" around mild obstacles. If not either the gearing is too high, and/or the carb needs adjusting!

Regards,

Alan
Seattle

------------------------------------------------------------------------------
"GaCruisin" wrote:


> i find myself ridin the clutch a good bit in tight situations. This is probably really bad but it seems necessary?

__________________
1979 Fj40 31in mud terrains other than that stock
 
LOL. Ok, I guess I'll go and play with the clutch when I have time.
 
lol, WTF? :D
My cruiser loves to have the stickshift "played" with. :D
 
Ok, so, looks like I might get to paly with the cruzah sooner than I expected. Its missing a lot of pieces to get registration and plates, so I will just have to drive it around the farm wheres its located. Theres only driveways with gravel. Would it be ok if I used 4x4 on the gravel or would I bind it up? And if I have to, I'll take off the X-Fer @&@&@&@&f gate so I can do 2-L. How hard is it to remove the gate?
-The Original Trevor

Edit: Looking at the FSM here, I'm jealous of the 4spd's 5.30 first gear... The 3spd only got a 2.75! The 5.30 provides a 50:1 as opposed to a 26:1. Damn, I want a 5.30 first gear

Edit2: Ok, I'm on page 2-10 in the FSM and I'm looking at piece #3. I'm guessing this is the xfer shift gate? This thing is under the boot? What tools will I need to get to it? Will the knob fit through the hole? After this is removed, you can just drop it into any position from any where? School me.

Edit3: This is a 10/73 FJ40ST, does this have the 3.70 diffs, or the 4.11s? And, whats a FJ43?
 
Last edited:
player said:
Ok, so, looks like I might get to paly with the cruzah sooner than I expected. Its missing a lot of pieces to get registration and plates, so I will just have to drive it around the farm wheres its located. Theres only driveways with gravel. Would it be ok if I used 4x4 on the gravel or would I bind it up? And if I have to, I'll take off the X-Fer @&@&@&@&f gate so I can do 2-L. How hard is it to remove the gate?
-The Original Trevor

Edit: Looking at the FSM here, I'm jealous of the 4spd's 5.30 first gear... The 3spd only got a 2.75! The 5.30 provides a 50:1 as opposed to a 26:1. Damn, I want a 5.30 first gear

Edit2: Ok, I'm on page 2-10 in the FSM and I'm looking at piece #3. I'm guessing this is the xfer shift gate? This thing is under the boot? What tools will I need to get to it? Will the knob fit through the hole? After this is removed, you can just drop it into any position from any where? School me.

Edit3: This is a 10/73 FJ40ST, does this have the 3.70 diffs, or the 4.11s? And, whats a FJ43?

first up, it might bind on the gravel, mine does. if it does, you can reverse hard (try to get the wheels to spin) or better yet jack one wheel off the ground to release the binding. if you don't drive far the binding shouldn't hurt it.

the gate is easy. follow the t case shifter through the floor, it pivots on a "stick" with a nut on the end... undo the nut, remove the shift gate. simple (unless 3 speed cases are vastly different). do it from under the truck ;) simple

if you do the mod, you can go 2high - neutral - 2low or into 4x4 from wherever the shifter is (of course if your in neutral, you'll go into neutral with the front output engaged). of course you gotta go through neutral AND down into 4x4 to go 2hi to low4... but it doesn't matter which path you take

i think that 1st gear stat is for the non US 4 speeds, but we also only have a 2:1 t case... so the gain isn't as much.

an fj43 is a mid wheelbase with a 40 series front end (and petrol motor). mid wheelbases have a wheelbase around 100 inches from memory

from memory, the 73 has 4.11's
 
So, actually... I could have a front wheel drive cruiser w/o the shift gate?

So the FJ43 is longer than a 40? Thats odd, I think I've seen the pics on the first page of SOR's OnLineCatalog. Where were those sold?

And if it does bind, all I need is one wheel off the ground? What is this "reversing hard"? It sounds... violent... :D
 
player said:
So, what if I was near stallin, then I kept giving it more accelerator? Wouldnt that increase the RPMs and make it not stall?



hammer down, till something breaks is the way to go
 
player said:
So, actually... I could have a front wheel drive cruiser w/o the shift gate?

So the FJ43 is longer than a 40? Thats odd, I think I've seen the pics on the first page of SOR's OnLineCatalog. Where were those sold?

And if it does bind, all I need is one wheel off the ground? What is this "reversing hard"? It sounds... violent... :D


No, 2wd low (rear)

cruiser cases don't have front dig option
 
bad_religion_au said:
get out and practice it... geez, it's like people that ask for handbooks on sex... you have more fun figuring out as you go along.


Well, I would if I had the opportunity, but the only thing straight drive I can get my hands on is a Civic Hatchback, and that isn't all too often. I want to read up to pass the time and be a little better at it when the UREs open back up and I get behind the wheel of my bud's Heep again (only thing stick I've ever driven off-road).

I'm guessing you assumed that I had a 40 or 55 since I posted in here, but I saw this discussion and figured I'd ask.

Reckon I'll just have to wait till spring to learn some more...
 
Well, I'm gonna see the cruisr today. Hope I get to drive it around the drive way... I think the gas tanks empty tho. Since the gas is like, 7 years old, is there something I should dump in the tank to make it run better? I'm gonna crank it over a few times to get the oil circulating... Oh, and the rad. leaks a little. How can I temp. fix that? I'll have dial up, I think.
 
Back
Top Bottom