Aussie Locker install Question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Trollhole

THC
Supporting Vendor
Moderator
Joined
Mar 6, 2005
Threads
1,565
Messages
21,212
Location
Mauldin, SC
Website
forum.ih8mud.com
I installed it last night and everything went smoothly but I have a few stupid questions.

This shouldn't go back in right?
IMG_2709copy.jpg


And I should be using 80w gear oil. Will a synthetic blend hurt?

And it seems to me there is not much holding the c-clips in except for the caps that come with the locker. Am I just paranoid?
 
If you can figure out a way for that to actually go back in there and run the aussie locker I'd be amazed! No... It doesnt' go in there.
 
80w-90w synthetic blend gear oil is fine...

I was wondering if any of the following issues could be associated w/an aussie install?

1) decreased MPG
2) subtle lean to passenger side during take-off or hard shifting


highjack over,
manny
 
mr_manny said:
80w-90w synthetic blend gear oil is fine...

I was wondering if any of the following issues could be associated w/an aussie install?

1) decreased MPG
2) subtle lean to passenger side during take-off or hard shifting


highjack over,
manny

yes yes and yes. i was paranoid when i put mine in too but shes been runnin fine, runs over anything too
 
Back
Top Bottom