99 uses for OBA

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 24, 2013
Threads
87
Messages
1,155
Location
Santa Monica, CA
Mapping out my on board air system and looking for some input on what I should plan for. I have elockers, so the primary need is tire inflation. I have a 6 hole manifold lined to an ARB Twin. Planning two air solinoids for future expansion. Aside from line air, I am considering air bags in the rear coils for heavy loads, and perhaps a pressure line for a water tank. Hit me with suggestions as it’s easier to plan for it now vs build it in later. It’s a blank slate!

97D2CCF8-7A55-4CC2-AA5C-DB7927BD32EE.webp
 
Pneumatic blender maybe?
 
Tire inflation, air bed inflation and some power tools. After that I start to mess with frogs...
 
On my Piggy with a York, I had an airline running to the drivers seat. I teed it off so one line was an air chuck for a line with an air gun for dusting me off and blowing out the carpets and upholstery. The other side of the tee went to a lever operated air valve that went to a set of 5 air horns in the fenders. The system had a 3 gallon tank, so I could run the horns whenever the tank was full. VERY effective for traffic control!!

:bounce2::bounce:
 
Train horn
 
BIG HORNS require lots of air. My York with a 3 gallon tank was probably too small to push real big horns.
Sounds like an excuse for another tank.
 
Pneumatic blender maybe?

I got a pneumatic blender but I have a york and it's a big hit during camp outs. I use a Butterfly impact with a 1/4" socket adapter.
 
Back
Top Bottom