Hello. Working on a newly acquired 78 FJ40.
Base plate under the carburetor has two vent lines- left hand is slightly smaller than the right. PO had the smaller left side opening connected to the Blue VTV, and nothing connected to the larger right side opening. My Haynes manual shows that the...
We put in some new gaskets on our hard doors. We believe that we put the wing vent hardware back together correctly, but the wing vent will only open about 2.5"
It has been 8 months since we tore the doors apart, and I don't know if we have done somthing incorrectly. It seems like the wing...
Changing the charcoal cannister on my 60 for an A/M model similar to one many others have posted with before. I understand plumbing for the reduction of the 4 vents to the two included on the new A/M cannister and have fresh hoses ready to go.
When taking of the hoses, the Outer vent control...
Is it normal for the wing vent lock gap to be this big. it is about 3/8" gap between the lock and the frame of the wing vent that the lock should be pressed against..
Hi guys,
Using @cruisermatt ‘s vent hose replacement kit and all has gone great with it. I’m chasing a gas smell on the cab issue so figured I’d search for a clogged vent line. All the hoses looked fine, but I stick a very thin screwdriver into one of the metal ports the lower vent hoses attach...
Hey,
I have a 76 40 series US model... Does anyone know how to remove the metal box inside the glove box on the right hand side (I think it is a speaker cover). Mine currently has a rodent nest in it and I would like to clean it out and put the space to some use.
Thanks in advance for any...
I bought a 90917 fuel line check valve a while back to see if it helps with some in cabin fumes I'm trying to rack down. All lines are newer, so trying to find the source of the smell and thought I'd knock this out. But, the existing check valve I have in place has larger barbs and it fits the...
For sale is a pair of rust-free, FJ40 wing vent windows. Frames have been sand blasted and primed. Glass has a few small scratches, but overall both are in good condition. The glass is sealed into the frames with new sash channel filler (1/16" Sash Channel Filler | Steele Rubber Products -...
I have heard that others are using a bike tube as the gasket for a FJ40 front vent window gasket. We tried this, but the bike innertube as too thin. For those who have done this in the past, are you doubling the innertube to get the correct thickness or ?
I have done a search on IH8Mud but...
Hi All,
New member here, and been searching for comments on this, but not finding much.
I have a 1978 FJ40 and it has the vent in the front of the windshield that is maybe 12 inches by 3 inches in size. When I got the vehicle, it was full of water, and doesn't seem to drain or have any way...
Just added to our GARAGE STOCK-1 Section:
A/C Controller with Vent, ND / Toyota 55-Series Land Cruiser – Used
https://redlinelandcruisers.com/product-category/garage-stock-1-garage-stock-1/
Hi to all - new 2005 LX owner, just flew down to TN and drove her back to Denver. 260k, but very minimal wear. I finally found my creampuff! HOWEVER, and I know this is common - but does anyone have any experience repainting the a/c vents next to the nav/HU? Very simple to remove, but one...