transmission

Hey Everyone. I’ve got a brand new OEM H55 F/H input and splitcase that were for a build that never came to fruition. It’s a drop in ready unit fully assembled with shifter and shift knob. I think nowadays this set-up runs about $6k. I’m asking $5k plus shipping. If you have any questions...

Yeah, it's Chinesium, but for home shop use I'd guess it will likely stand up to typical use. I ordered one. 1322 lbs. Transmission Jack Hydraulic Telescopic Floor Jack 2-Stage Stand with Foot Pedal 360° Wheel for Garage Shop...

Pulled this powertrain out of my personal FJ80 to do an LS swap. I have the full engine, emissions equipment, air box and meter, ECU, and all accessories. Price includes the A440 trans with ECU and tcase however I will need parts of the harness to facilitate the LS installation. The engine...

For sale complete 1fz-ft coil park and h151f engine harness computer Take off 1998. Toyota Land Cruiser 105 has 200xxxx k km. Condition running great shift smooth Why I’m selling I’m doing swap 1hdt-ft and h151f in to lc105 Ask 10k . Pick up at tj auto 7564 park avenue garden grove 92841...

Carburetor. 0H27 stamp. Believe to fit 08/80 - 8/87. $175 shipped Unsure of running condition.

What is a reasonable price for a 1fz-fe and transmission from a 1995 landcruiser with 265xxx miles, engine is leaky but runs fine and tranny shifts good? Only selling them as I'm ls swapping!

Looking for a full set of bolts to attach the front half of the split case to an H42. This is an early 60, so no spacer on the H42 - shorter bolt set. If there's a good substitution out there, I'm all ears. So far no luck.

Hello everyone! I’ve been lurking for awhile and this is my first post here. I’ve had no luck finding any answers. Can anyone tell me what this part does? While inspecting the trans to try fix a code I found a piece of metal wire hanging from this metal spring loaded button. The button is...

Hello everyone. I’ve been using MUD as a resource for my 2013 LX over the last year but this is my first post. I took a trip to Death Valley eariler this month and while descending this gnarly mountain I tripped a P2716 code for my shift solenoid in the trans. This lead to a flashing 4Lo and...

Decided to hurt my resale value and do an LS swap. :rofl: In Lawrenceville GA. Would prefer local pickup. $1500 obo Current mileage is 329114 Engine is in good running condition. The alternator will need to be replaced. The engine has not been overheated but if it is pushed hard on extended...

DUI distributor w live wires. New $400

Scratched the rear shaft of transmission while pulling the seal. Any suggestions to fix it? Or is it not a big enough scratch to cause a leak

Looking for a 1HD-T with matching A442 hydraulic transmission. I have a 1991 FJ80 with the 3FE getting ready to swap, if I can find a good diesel setup for the right price I will pull the trigger.

Selling a red 79-82 transmission cover plate that bolts to the body. Will post pictures up when I get home $75 plus shipping

Looking for the full package. Front and rear R&P plus install kits for open diffs. Ideally someone that has them sitting around and isn’t going to use and looking to do cash + trade.

Misc FJ80 parts from 1994 FJ80 and 1996 LX450. Including nearly rust free body for the LX

I've got a good transmission out of a 1994 FJ80. Asking 400 Videos available of it running. Just removed in March. No transfer case. No engine.

Have a transmission and transfer case from a 96 80 series with 167K on the clock. Everything worked as it should prior to removal. I still haven't separated them so let's say $350 for the entire unit and that includes the torque converter and the transfer case shifter. Transmission or transfer...

I have a 2F engine paired with an H42 transmission. Besides the H41 and the H55 what transmission would directly bolt to the H42 bell housing or to the 2F?

Asking here as my trans has more in common with yours than an 80. Is converter lock up a function of the vb or is it controlled elsewhere?