transmission

Ceramic coated , planed/machined ready to install 3FE exhaust manifolds ready to install $500. Shipped to lower 48. Note: EGR port has been welded shut and shield bosses have been removed. I was going to use these on a 2F but couldn't get machine shop to thin the flange to match up with 2F...

Looking for an R151 transmission for my LN106 Hilux. I am rebuilding my 3L diesel w/ turbo and need to upgrade from the G52. Would consider a good core but would rather buy one in good shape.

Closer to Louisiana the better. Anyone got an A340F sitting around they don't need?

I have a used 1FZ-FZ late model manual transmission ECU. This comes from a truck with factory non EGR and non O2 sensor setup. So no check engine lights for a manual swap and no EGR codes. $400 USD

Parting out a very interesting 96 (build date Jan 96) 80 series. Will list the major parts in their respective categories here on MUD- if anyone is interested in anything specific please contact me via email shmukter@pa.metrocast.net Truck has 166K miles and was a daily driver until rust...

Is anyone running Toyota WS ATF in their 94 transmissions/A442F? Apparently I'm horrible at searching through the forums for an answer, lol. Thanks, James

$300, pick up only Swapping 3FE into my 40 so don’t need the trans. Was told it worked fine but have not personally ever run it. No metal flakes in fluid, output shaft is a bit worn though. Comes with torque converter, flywheel, and bell housing.

I have a 1990 auto 4Runner with a blown engine in the US..so I’m wanting to swap out for a 2l-te mostly because it’s my understanding it could swap over to the current automatic transmission bellhousing and it will be reliable. Any info on this route would be very helpful 🙏🙏

Hi, this has almost certainly been covered in another thread but I can't find it. I have a 1994 1hdt factory triple locked. I've fitted a new genuine switch and it works in high range. But my transmission control relay is different to all the others I can find mine says "computer, 4wheel...

So I put another motor and trans in my rig after the original ones started to develop problems. 1Fz-fe/A343F. I am to the point in my project when I am ready to get it back on the road soon. I am trying to figure out why it is barely moving in drive. The rpms go up high (3-4k), and it takes my...

1992 FJ80 3FE block which has been cleaned and inspected, .014" wear (worst) to cylinders with some pitting from sitting, machinist stated that .030" would clean her up. Purchased this LC with the engine pulled (complete/not opened up) last fall. She's nice and rust free but PO stated she was...

We rebuilt this H55F recently ( all new bearings and synchro rings ) but then decided to go with a different engine. $2200 plus shipping ( within the US only ). We can also supply a shift lever and shift knob, as well as any transfer case components needed. Georg @ Valley Hybrids @ Cruiser...

I purchased this vehicle in the late 90's. Over the years I have changed it to a 5.7 Liter (350) chevy engine and automatic transmission. Also added Dana 60 axle with disk brakes in rear. The front axle is a Dana 50. They also have ARB air lockers and 37 inch Goodyear Wrangler tires. An Atlas...

On my way out of the neighborhood today, my ‘93 HDJ81 with the a442f auto transmission upshifted VERY hard on a downhill and I started hearing a cyclical metal-on-metal sound. I turned around as soon as I heard it and parked the rig. At quicker speeds (15-20mph) I couldn’t hear the sound but at...

Hi Guys I have a FJ40 4 speed trans that I am trying to Identify. See photos. has different number of teeth on the Engine side. Super clean and smooth. I want to sell.

I'm working on getting my 76FJ40 back on the road, it's been sitting for 15 years. Drained the transmission and was full of water from past offroad use. Transmission will not shift. Any recommendations on what to try and put in it before rebuilding it. Transfer case seamed to be ok. It's a...

Hey mud, I've had my 97 fzj80 for 5k miles. When I first got it I replaced the valve cover, the hoses, and the radiator. I also replaced the fluids and got new tires. A couple of weeks ago I noticed a smell coming from the car when I drove it. Yesterday while driving I saw the temperature gauge...

Transmission access panel. I have two for sale. One has a broken bolt in one . The other has a small portion at the rolled section that had rust on the underside. Both have been sandblasted and primed using a 2k epoxy. $75.00 each plus shipping

Looking for a pump out of an A442F, Toyota Part Number is 35035-60010.

Got a cross member for an FJ60. I bought it to do a H55f conversion into a 62 and end up using an early mount and cross member. So this one not needed. $200 plus shipping.