transfer case

I’ve had an intermittent issue with my 4WD dash indicator light, and when it finally went out I traced it back to the switch screwed into the side of the transfer case. This is the switch that when engaged, closes a circuit that lights up the dash. It’s a little confusing what part this...

Hi all, My 01 LX470 with 200k miles has given me a bit of trouble this week. The fan clutch bracket went bad, so I decided to replace the timing belt, water pump, along with the fan clutch. I thought I would be good to go mechanically for a while. The very next day my wife was driving it and it...

2003 Lexus GX470 weird noise

Can anyone recommend anyone in the Midwest (I’m in Indiana) to rebuild 4sp and transfer case in a 1978? It needs syncros and bearings but runs and drives Im pulling it right now. Thanks.

I have a 84 fj60. The guy I bought it from told me the original owner hated the 5 speed and got a 4speed with a overdrive installed. I know nothing about this overdrive. The picture attached is of the side of the tcase. I looked up that company and they seem to have been popular with Land...

SoCal 1. Wiring loom is in good shape from a working transfer case. $68.40 includes shipping.. All connectors are good. 2. Transfer case with a growl in it. Complete unit. Great to rebuild with low range changed, underdrive to lower final ratio, or for part time conversion. $125 no shipping...

Well, I think I figured out why my 88 OJ50LV doesn’t move under its own power anymore, but I am shocked. Does this mean I need to pull the TC and Tranny, or just TC?

My 1993 has been leaking gear oil and I cannot determine the source. So far I assume it is the front output seal. Whenever I check the gear oil level it never seems to be low even though it leaves a sizable puddle every week. I would like to fix soon. What else should I be inspecting?

300K miles on this one out of my 1994 FZJ80. Both hi and low engaged, but no CDL light was coming on. On SD Trux recommendation, swapped it out for a used one rather than crack it open to rebuild. Pickup in Encinitas. Not shipping this beast. $100

Former lurker, new to posting on mud, not sure if this question has been asked or if this is the right place to post. If it has been asked or if this isn't the right place to post then direction to the proper thread would be appreciated. I have a 93 Cruiser and the front output seal on the TC...

For Sale. Used Transfer Case, was my spare and has been stored in my garage. **Correcting this, to be a 3 speed transfer case** $750. Local Pickup preferred. Located in Natick, MA. I'll ship, but likely have to build a box to put it in, and buyer would pay actual costs.

I have a pull-out setup from a 1972 FJ40 from when it was swapped to a 4 speed with the 4 speed transfer case. Rather than messing with adapting the 3 speed transfer case to a 4 speed transmission, he decided to just throw the complete setup in there (my boss' vehicle). So I have been tasked...

I am about to attempt to change my Transfer Case and Differential Oils. And I have already purchased 7 Liters bottles of Mobile 1 synthetic 75w 90 GL5 gear oil. My new plugs and crush washers from Wit's End are supposed to be here today. I wanted to know if anyone had a recommendations for...

Hi, looking for a transfer case shift boot from 9/72 to 9/73. They only made it for 12 months and they're hard to find. New or used. Thanks

Hello, I am looking for a linkage member for my 1967 FJ40. I have the original dash mounted, vacuum-assist 4wd, but the link I have, (shown below) I believe is for a 4-speed and is about 2-3” too long. I am hoping to avoid cutting this down and rewelding it to the correct size, so please let me...

Hey guys I am after a later 60/62 series transfer case must be the 38 mm idler. Let me know if some one has one for sale. Thanks

Hi everyone, I have a 2001 VXR Landcruiser 100 with about 450,000Km on her. I have a leak on one of my transfer case seals. I replaced the rear output seal last week but this leak is from a more central part of the transfer case and so beyond the tools that I have available. She's an old truck...

Hey guys, I have searched around mud a little bit and found some details on these threads. But nothing that 100% matched what I am seeing. FJ60 Transfer Case- Seating front output shaft https://forum.ih8mud.com/threads/some-h55f-and-split-case-tech.600279/page-13 1986 November (so 38mm)...

My dad reached into the transfercase on our 1965 FJ40 and found all of this inside. Assuming a bearing is just shredded apart on the inside but does anyone have any other info/advice/experiences with this, such as what it is or how do we fix it? Any help is appreciated.

Hello, I am almost finished with a drivetrain project but I am missing bolts! I need the 7 bolts that mount the split case to the h42 long (spacer in back) I don't know the lengths of these bolts either. If someone has that info I would be very grateful. So, bolts or even info, Thank you! -Matt