start

  1. T

    Intermittent Starting Issue - Can Always Remote Start

    I have a Clifford remote start unit that has worked pretty flawlessly until the last couple weeks. One out of every maybe 30 cold starts, starting the car via the key won't work. The lights come on the dash, but it doesn't turn over or try to start at all. If I lock it with the keyfob and...
  2. Karmapolice

    KZJ78 1KZ-TE Weird Start Up Noise

    This noise isn’t consistent, I have had it happen three times at this point. Best guess is maybe the starter motor is being slow to retract the gear and it’s still engaging the flywheel. Anyone have any insight or similar experience.
  3. landcruiserluke

    Will not start

    My72 fj40 will not start. It did start after winter storage but would run maybe on 4 cylinders. I came our of it after a short time. This actually started last fall before I put it in storage. Once the engine was warmed up , it would start and run fine. Now it will not start. It did briefly ...
  4. Hornliss

    Boost start psi?

    Hi all, I have the 100 series with a lot of mods, - SS 3inch exhuast, - badboy II green wheel turbo - Airmax Snorkel - upgraded intercooler - piggyback chip and tune - Trans cooler and locker - 2 inch lift with all the usual diff drop, control arms etc -Harrop elockers front and rear - oil...
  5. Sean Karzai

    INTERMITTENT NO START ISSUE

    Hello ih8mud community, i know this probably is the 50th crank no start forum post but i really need help. 2000 Land Cruiser 100 Series - 297k miles. Since about 290k miles i’ve had the infamous crank no start issue. Happens a few times a week. Have scanned for codes multiple times/ None. So...
  6. tputterman

    Hard to start when warmed up...

    First thing in the morning my 3.4 starts right up. Once I get to running temp and turn it off it takes 3-4 cranks to get it started. Within the last 10,000 miles I have replaced all spark plugs, injectors, coils, fuel filter, timing belt, and water pump. Could it be vapor lock? Stuck injector so...
  7. lt403

    Ignition has no resistance, no start

    Good morning everyone, Yesterday I was out running errands and when I got back to the car and turned the key I got dash lights but no resistance when I tried to turn the car on. There was no return of the key when I turned it to crank the engine. Hope I’m explaining myself. I did not hear the...
  8. zcostilla

    AC system not holding pressure… where to start?

    2005 LX470 and the air worked fine until about two weeks ago, when it started running weak. Was meaning to get to looking at it, but one of the fine joys of being disabled is finding that sweet convergence of feeling well enough to do the work, having time to do it, and weather to cooperate...
  9. Sherman Tank

    Relation between gauges not working and starter solenoid?

    I was away for 6 months and my girlfriend was using my HJ 60. One day, while at the dentist or something, it wouldn't start when she got back out. She had a few guys try to get it going, but couldn't, so she had it towed to a house where it could be parked until I got back in the country. I...
  10. mrjordann

    Wanted  1F crank start handle

    Anybody have a crank start handle for an FJ40? The one that you stick in your crankshaft pulley nut to start the engine if the battery is dead. Thanks.
  11. offroadvegan

    1993 1FZ-Fe Will not Start or Crank when HOT

    I was taking the fam to the Alvord desert this weekend, and stopped to get gas a couple hours in. The rig felt hot inside, but with an RTT, camping gear and 2 adults/3 kiddos, I figured it was just working hard. We stopped in Madras for gas and I filled it. Went to turn the key and click...
  12. T

    No idea where to start

    1fz motor 94 year The truck idles rough when cold. Still close to 2k RPM but feels/sounds rough. It is very very rich on a cold start. Most of the time, it runs fine once warm. Intermittently, it will stutter, shake, and nearly die for just a moment. This only happens during acceleration...
  13. B

    82 HJ60 used to start first time every time, now starts second time every time, any idea's?

    Was going to post up a video but no dice, non compatible.. simply i reckon the EDIC arm is playing up. Hit the go button and it moves to over-injection but doesn't start first go, start it -immediately- after and it turns over.. all the relevant relays click when they are supposed to, batteries...
  14. W

    Stall at start/vaccum leak

    So long start short I my car just Rieves and stalls when starting unless I absolutely floor it and hold the rims at 3000 for 30 seconds, also found this vaccum leak, help!!!
  15. A

    1FZ-FE Rebuilt but have a Rod Noise when Cold Start

    Hi, I just do a master rebuild of the 1FZ-FE. The engine is rebuild with 0.25 clearance not standard. I notice a BIG loud noise when cold start or when the truck is sitting for 3 to 4h. The Knock noise last for about 2 seconds! the times that RPM goes up and down when starting. What is this...
  16. pokerDawg

    '83 FJ60 won't start....HELP!

    The FJ60 has been sitting for about 2 years. I drained the old gas. Replaced the fuel filter. Put penetrating oil in the cylnders. Added 2 gallons on new gas New battery Sprayed starter fluid Turned the key and the starter tries to crank the engine but does not start. After studying this...
  17. Irish Reiver

    Keyless entry & Remote Start systems OBD1

    I want to replace the old keyless entry system which has now failed with a new model that also has a remote start function. My truck is a '94 so OBD1 (not sure if that matters). Does any one have real world recommendations ?
  18. RFB

    What is the advatages of the Power and second start buttons

    I re did the wiring for the IBs dual battery monitor and while I was at it, refinished the shift console and armrest. I had to disconnect the POWER and SECOND START. But what are they and is there any advatages to using them and when I guess is what Im asking.
  19. btbuild

    First start questions.

    Hello I have a 1/73 fj40 F engine that has been desmogged and rebuilt also has a New Troll hole carb. I am planning on starting up rebuilt engine this weekend. The engine is mounted on chassis without any of the wiring harness. 1. Do I have to hook up idle solinoid for start ? If so how do I...
  20. jdayment

    No Start Help

    Started a thread in the 80's section just wanted to see if you guys had any ideas 91 FJ80 No Start
Back
Top Bottom