running

My FJ80 (3FE) won't start, needs a jump every time, won't stay running at low RPMs. AND THE BATTERY checks out. My 80 will not start without a jump. Dash lights don't come on. Thought it was (naturally) the battery. Right? Nope, battery checks out brilliantly. Is does not discharge much if...

I'm already running the Lexus app on my iPhone but when tapping on the App on the dashboard screen, I'm getting this message. I remembered I used to be able to access the App.

I'm looking at purchasing some new wheels for my 2002 LX470. I really like the look of the Black Rhino Rapid wheels in bronze. However, the size I'm looking at (17x8.5) says that it's not compatible with my vehicle. The center bore of the wheels is 110.1 and the +10 offset should work from...

sold

I bring it up because I’m changing my fuel pump. After 24 years and 300K miles I thought it would be prudent, and easy to do. I bought a Denso replacement pump. When I got to it I found the Denso to be shorter than OEM and would require me to rewire because the connector plug has different pins...

Hey all, long time lurker, first time poster. I have a 1985 4Runner and have been having issues with it running a bit rough off and on for a bit now. I’m down here in Baja and don’t have a mechanic I trust and also appreciate doing as much as I can myself and enjoy learning, so trying my best...

Does anyone know what the rated amps are on our running lights? I have a 1997 and added a pair of LP9's and a pair of LP6's. I'd like to use the hot from one of the front marker/running lights to power them instead of using up a slot on my SwitchPro 9100. Also don't want to overload that wire...

I know, pretty specific configuration. I'm pretty sure my FF snorkle will clear the Dissent RR as that has been covered in another thread. What I'm trying to determine is if I go with a Bush Co 270 styple awning on the passenger side, will I have any interference with the snorkle? From pics...

As titled. Prefect shape. $175 + shipping

Purchased wrong model by mistake (needed FZJ80 running boards). Used part in great shape (no rust/damage) Running boards only, doesn't include mounting hardware Paid $450 for the pair, willing to take $350 to avoid shipping them back/restocking fees. Located in Annapolis MD.

I am after a clean set of running boards for a 79+ FJ40 with the little notch in them where the tub/cowl seam runs down. Please message me if you have something to sell. Thnx

Hi, everybody I have a LC 100 2005 with 230.000km on it and have had an issue with the slow response O2 sensor fault. I installed a new DENSO O2 sensor (the old one looked aftermaket) no codes now but bank 2 short term trim is -20 and the long term trim is +20 but only on bank 2 where the bad...

Padded running boards with retainers. $60 plus the ride

Good morning folks! My 2000 LC for the past couple of weeks as it’s gotten cooler has begun dying when I start it up. It will idle normally for about 5 seconds and then cut off. When I restart it will run very rough like it’s missing and die again unless I rev it and let it get it out of its...

For sale: Used 1994 Toyota Land Cruiser Running Boards Complete set with mounting hardware. This was painted while it was on the truck a couple of months ago but I decided to take them off. No rust, local pickup only.

I'm looking for a pair of running board supports for my 73 fj40. These are the pieces that bolt to the frame and extend out underneath the boards. Light surface rust not a problem but I don't want anything heavily corroded.

Looking for a long block for a 95-97 long block that was running prior to being pulled. Located in the Seattle area but willing to pay for shipping for the right motor. Open to other options as well!

Out of nowhere my '07 LX is running and idling rough. It threw a P0302 Cylinder 2 misfire code. Any thoughts on what this could be? My first instinct is a bad coil pack

1976 Toyota FJ40 Landcruiser 2F engine. I've decided on a diesel swap and am selling one of my 2Fs. I got this one running before pulling, was not able to get a good compression test due to weak battery at the time but I remember numbers being even and seemed to run pretty good and planned on...

I had an old post that contained this, but other things as well (which are now resolved.) So, 1976 FJ40. Lights work. Start the engine and the headlights turn off (running side lights stay on). How in the world would that be happening? I've got a headlight switch replacement on the way...