mounting

Over the past few months I've been neck deep in On Board Air (OBA). I've been heavily focused on the 8o Series but since I've had access to a 200 it was a no-brainer to work out similar solutions. The two most difficult pieces of the system are the compressor and the air tank. For the...

I bought my early ARB bumper used. The previous owner had a winch on it, but he would never respond to my messages on how to mount it. Should the bumper have a plate for the winch to attach or does a generic plate come with the winches? I'm confused, help.

After having my emergency triangles floating around the truck I wanted a good out of the way location but was accessible. I found this mounting bracket. Amazon.com: Triangle Kit Mounting Bracket: Industrial & Scientific The triangle case I had was a little short for the mount so I used a...

I'm about to start on my front bumper and I had a few pre build questions for some of the more versed 80 guys/gals. I'm going to be building my winch plate/bumper center section out of 1/4" plate and finishing the rest with 1/8" plate. I'm wanting to keep the bolt on design but I was wondering...

I am doing a minitruck PS conversion on my pig and am looking for a bracket to mount the gearbox.

Hi, due to a recently increased count of family members I bought, for my BJ42 from 1983, a front facing rear seat. Unfortunately any information, like e.g. exact model where it comes from and required parts to mount, is missing and I couldn't get this from the seller. Can anyone help me with...

I just bought a 97 Trooper and need some recommendations for a shop that can help me fab some simple brackets to mount my (very heavy) steel bumper w/ winch. The previous owner had made up some brackets but they weren't strong enough and failed during the recovery of a stuck in and upside down...

I've searched already...but wonder if y'all might have found something I haven't... So I love the Front Runner system...but I don't like how HIGH it extends upward. I know they have a table you can mount under it...but sheesh. The rack is 6 inches tall. I see this Baja Rack "Utility (flat)...

Here's some better detail of the factory front mud flaps and the 2 screws. Part numbers: 76603-60021 and 76604-60021 "*MUDGUARD SUB-ASSY"