line

Will the 72 hardtop fit a 74? I have a line on on one for my 74.

Making the jump between a Fuel Pump tube 77209-60160, the breather tube 95312-13028, fuel hose 95337-06009, clamps, and the tubes on the body. I think I have everything that I need to reconnect the new fuel and breather tubes from the body to the new lines. The one part that raises a...

Twice now I’ve noticed the line connecting to the rear diff was unplugged. That leads to tell me that the line isn’t long enough at that spot. Can someone refer to me a part to replace that line? It’ll be a good time for me to extend the breather line up higher, too. Thanks!

Have a leak (rusted) in one of the steel lines coming of the booster. Trying to find a detailed diagram for part #s. Thanks in advance.

well guys/girls, title says it all....need knee surgery so will be down for x months. Any referrals to a knee only doctor? Just remember, when in doubt, straighten 'em out🛻

The AC lines below my passenger door are showing signs of leaking. I took off the insulation and the brackets and could not find the source of the leak. I took it to a local shop to have the AC recharged after replacing the AC condenser and they also could not find a leak and said the system...

Looking for the two different fuel hardline brackets for an FJ40 circled in the photo. Located in Woodstock,Ga

Hello, Does anyone know the part number to the spiral brake line that connects to the brake master cylinder? I ended up rounding one of the heads :/ 1993 land cruiser Thank you!

Looking for recommendations for a good brake line flaring tool you have had experience with using.

Has anyone every used red line cruisers charcoal canister bracket before below?Just wanted some feedback on it. Thanks https://redlinelandcruisers.com/shop/engine/rl1006-charcoal-canister-heater-mount-1974-1984-fj40-toyota-land-cruiser/

Good evening I am currently camping in Colorado and noticed the ahc line above the rear axle leaking from corrosion. It’s the 48998-60010 p/n. The line has a foil wrap to protect from heat of exhaust below it. The rust was at the edge of the foil. Yesterday I towed a small camper here, now...

Hi All - I have a 1996 LX450 and a section of the hard brake line that runs from the front to the back blew out. It is the area under the car that lines up with the front section of the rear leaf springs (hopefully that makes sense). I am in the Lake Tahoe area and my mechanic says they have...

Sold my 100 and never got around to installing. Slee 100/ LX470 braided brake line kit. NOTE: This is only for 98-99 years. Slee part STF1088. $125 shipped firm. These are brand new un-opened.

I bought a 90917 fuel line check valve a while back to see if it helps with some in cabin fumes I'm trying to rack down. All lines are newer, so trying to find the source of the smell and thought I'd knock this out. But, the existing check valve I have in place has larger barbs and it fits the...

I am looking for the two copper lines that connect the front and rear heater with engine. See photo for better detail. Thanks

I was going to do preventative maintenance on my PHH, so I ordered the silicone hose kit with clamps from PHHKIt (Pesky Heater Hose Kits - http://www.phhkit.com/). Later, when I pulled my PHH hard line the original paint was completely gone, and there was severe pitting where the PHH...

Hey guys back for yet another adventure in my 1998 LX470 that I bought on a whim here in Georgia, for a mere sum of $1800. As you could have guessed it, the car came with some issues, and the seller was not very upfront about them from the getgo. Though he may have thought he was slick with...

OK guys i need some help i finally got my baby running again after starter issues only to attempt to pull it out of the barn when I lost all brake pressure. needless to say after an hour of troubleshooting and bleeding i found the the rear hard line going across the axle had a pin hole in it...

I bought a well built 2002 100 series with a TJM front bumper housing a Warn VR12000 winch (my first winch). I've used the winch to move some downed tree from trails, and cars stuck in snowy parking lots (light work) - but never had the line out very far. I haven't had success getting it to...

Does anyone know what size the vacuum lines are that control the butterfly valve to kill the engine? in mm please, outside diameter. I have a leak and need to order some new lines but not sure what size to order. THanks!