leaf

I just installed new Leaf Springs on a 1986 FJ60. I did not put this plate on the top and the rubber on the bottom when I installed new springs. Should I have done this. Or dose it matter if I don't do this. The springs are old man emu.

whats the best advice for a little cosmetic rehab? Im planning on using my stock leafs in this picture. I was going to pull them off and paint 1. Should I paint as whole unit after some wire brush work 2. Pull them a part have them blasted and painted Road warrior rehab not a nut and bolt...

I'm relatively new Landcrusier owner. I'm learning about the wonderful world of rolling restoration, maintenance and stuffing mitts full of $100 bills into my BJ to fix things. Still love it. Just installed an OME suspension system and now see that my 81 BJ42 frame plates where my rear spring...

I need to get some new rear leaf springs. The current ones are 43" long 19.5" from front to mid and then 23.5" from rear to mid. Problem is they are older and since i put the new engine in i am getting crazy axle wrap which has broken/loosened the c clamps for the springs. See exhibit A and B...

iso factory shackles and leaf pins for my 70 rebuild shoot me some pictures and prices if you have some

I need to weld some new spring plates on my doffs as the centre pin holes are ovals out. Can any tell me what the pin diameter is? Stupidly I cannot measure off my springs as I got rid of them. I suspect that the hole should be 19mm diameter?

Hey all. I'm new to the 4 link world. I would like your opinions on what direction I should go with my 1992 single cab. I tow a stramcleaner skid with a 200 gallon water tank with it. Currently IFS lift running 36" tsl swampers. 5.29 gears. I'm looking for the best riding, performing on and off...

I noticed a my passenger side front leaf spring stack has shifted - springs have moved so a couple of longer leafs are net stacked straight. I get an occasional clunk from the front leafs when cornering, and that got me looking at the springs. I have tapped them into alignment, but they will...

I am trying to figure out what sort of suspension lift I have on my '78. I believe it was set up with a very sturdy/stiff suspension, and since I am 95% on road driving, I would really like to soften it up. I don't know a lot about suspensions, but I know I have seen 3/4 ton trucks with...

looking for a set of rear leaf springs for a 76 fj40. I have a broken leaf in one.

I apologize in advance if this has been asked/answered in a separate thread. I'm new to the group and new to Land Cruisers, owned a few Jeeps over the years. My question is the previous owner did a 5 1/2 inch spring over axle lift on my 81 FJ60 and kept the stock springs. He also added custom...

For sale - 60 & 62 SERIES FRONT HEAVY DUTY LEAF SPRING- Item 287-600-FHL Heavy Duty-2 inches to 2 1/2 inches of lift over stock height-Fits 8/80-1/90 60 & 62 Series-For Cruisers with added weight from accessories (bull bars, winches, roof racks, etc.)-5 leafs per stack-Uses large 3/8 inch center...

Upgraded springs to OME. Were not sagging at the time of change. No longer have a use for them. Local sale only.