front

Hey all, I'm just doing a sanity check on my 2000 LC.. It was well maintained prior to my ownership. I was setting up a weekend to change out the drive shaft ujoints (clunk in drive and squeak in reverse) And I checked the front wheel bearing doing the 6 -- 12 push/pull and when cold there is...

Bearing is spinning on mine. Looking for a good condition replacement. Thx 770 298 7668 Greg

My LC is a 6/79. My question is, am I hurting anything by driving it while this is happening? I have not put it in to four wheel drive and don't intend to until I get it fixed. I would just like to run around town and give the kids a ride when it is nice.

Thanks for taking a look. This bumper is designed for 1998 to 2007 Toyota UZJ100 and Lexus LX470’s. It is a 3 piece design (center section and 2 outer sections), individually welded and surface finished. It’s all aluminum, with the exception of Grade 8 hardware, and an optional steel winch...

I am looking for an ARB or similar type front bumper for my 94' 80 Series. I am located in Southern CA

I completed my PT conversion on my 1992 FJ80 over a year ago. It was a great decision and I would recommend it to anyone on the fence. This is NOT my daily driver so I didn't do it for improved fuel economy. I did it because it seems to be much easier to drive and reduced fatigue on long highway...

Was sent these by mistake, fit '98-02 (04465-60220) and I've got a '06. $55 + ride Tucker

Looking for a used OEM 60 series front blower motor and looking to pay around $50 plus shipping to FL.

Hi all, I tried to fix my power seats and ordered new gears from gamviti. After reinstallation of the seat, It still won't slide... I've given up and want to just order new seats (don't care if it's manual) Anyone know where I can buy new seats? Thanks!

Hey everyone. So we all know that tires aren't cheap.... i've had my 80 for almost a year now and when i got it the first thing i did was put new treads on the rig, eversince i have noticed that my front tires are wearing on the outside more than on the inside and the left side more so than...

Yea I know no cruiser sits truly level, but I put a set of OME HD's on the 60 last September in preparation for a load, and I'm not that loaded yet. The skinny on the truck: From the fender lip. Drivers side. 40 front, 37.25 rear. Passenger side. 40.25 front, 38 rear. 2" body lift also. I...

Just picked up my 01 LX470 from the shop. Had tons of work done to it so it could be drivable, and the mechanic told me I needed to get my wheels balanced. Side note, one thing fixed were sway bar end links. I drive it around town and it felt fine, but as soon as I got above 50mph, my front...

PM me if you have two in decent shape.

Fj40 front hardtop windshield cap. Surface rust. Good condition. $70.00 Plus shipping.

FJ40 front bib. Good condition. Original paint. $200.00 Plus shipping. Price includes a front bezel. Bib hinge not included.

The flange/studs/cone washers took quite a lot of convincing to get off after 17 years. Some of the studs got a little mangled in the process. Does anyone have the part number for these as they aren't even shown in any diagram I can find. Talking about the studs/nuts that hold #4 on in this...

Factory speakers are out! Installed some jbl 6.5 with factory grill.

Looking for stock fj80 front springs. Let me know if you have a pair. Thanks, Blaise

Does anybody have a p/n for a front receiver hitch for an 80 series ? I'm wondering if it will cross reference to a more common rear receiver hitch for another vehicle, I might be able to grab at a pick&pull ?

Looking for a used ARB Front Bumper (winch model) for a LandCruiser 80 series or Lexus LX450. whatcha got? BTW, I'm in California