Selling this BJ60 Front grill OEM with Turbo Tag not damage .
https://www.ebay.com/itm/134925712630?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=vl_39ym2q2w&sssrc=2524149&ssuid=vl_39ym2q2w&var=&widget_ver=artemis&media=COPY
Hello. I am looking for a set of interior door panels in the years 1981-1985 brown pattern.
Also need rear cargo panels as well.
Good to excellent condition.
Let me know
Thx
As the title says. It was the original transmission from my buddy @FARMAN33 from his Silver Surfer 60 series. He swapped to a 5 speed and I bought it for my 60 series before I could afford a 5 speed myself. I did a new 5 speed and split case from Georg, so this never got used.
It's house...
I've heard Bearden and Landcruiser specialists recommended for land cruiser work in Austin.
If I need my 82 fj60 transfer case rebuilt (front output bearing is shot) who is the right choice in town?
should I go with a trans rebuilder?
My mobile mechanic doesn't do that sort of thing.
What...
Hello,
Posted in workshops as well, but the truck forums get much more traffic.
Just as the title says - I'm designing a garage, and I finally get to put in a lift. Going 2-post as space is a consideration, and most of my work will be wheel rotation, brakes, etc. - need the wheels accessible...
Hello,
Just as the title says - I'm designing a garage, and I finally get to put in a lift. Going 2-post as space is a consideration, and most of my work will be wheel rotation, brakes, etc. - need the wheels accessible.
The cruiser is the tallest car I own. Others are an 89 911 and an 03...
I’m trying to wire an aftermarket radio, these wires were right behind the receiver slot. The left two wires are showing 11-14 volts on a multimeter regardless of key in on position. I want to wire the receiver to constant and switched power. Will if have to fuse tap for switched power? Or what...
Hi all,
First post! I've been slowly working back to life an '83 FJ60 and loving every [most every] minute of the process. Attached is a photo of corrosion on the driver side wheel well and quarter panel. This is the worst of the two sides and appears to be the biggest body issue I am dealing...
got a steering box here off a FJ62 that didn't leak but was oddly kind of too tight of steering? Not sure what the deal is with it but we put an 80 box on. $100 plus shipping. No pitman arm but can include either 60 or 80 version with nut and washer for $30 additional if needed
I adjusted the valves to spec and timed it with the light gun at idle (many thanks to responses to my questions on how to get this far). Previous owner had done a "partial desmog" according to people who saw pictures. Now that the rebuild is done I want to know where I need to run vac tubes to...
$20 plus shipping cost. Pulled from my 1987 FJ60. These have a little surface rust, but they are in working condition! I bought new ones, so these have to go. I’ll include new adjusting springs. You will need screws for the silver ring trim, though.
Hi All,
I am in need of (1) stock FJ60 wheel if anyone has one laying around. Turns out one of them on my truck is bent. Would anyone have one available?
I am in Illinois 60901.
Thank you
Asking about half of new, $600. Done by a local reputable shop where @Wadesters takes his restoration level tanks to get refinished.
I can assist with delivery throughout the southeast.