engine

Comes back ON, on pavment....🙄 I guess it's time to find the broken wire in the #1 O2 heater circut. Or just spend more time wheeling... She seems to like it. :)

Took the old girl for a ride yesterday, and after I got back I was checking for leaks and noticed the back of the oil pan where the curved part sits on the last main bearing cap was wet, and there may have been one drip. I wiped it dry and this morning there doesn’t appear to be any fresh...

I just pulled this engine and transmission out of my 1989 fj62. The engine was running when pulled, but was getting blowback from cylinder 3. It is a complete engine and transmission, does not include the transfer case. Transmission shifted and drove fine until pulled. 138k on motor and...

My engine light is on and my mechanic said it's because of the cats. The truck has about 400,000km on it with a motor replacement which has 270,000km 2007 Tundra 5.7 ( motor is a 2010 ) My mechanic says they can be cut out completely and my milage should be better. Does anyone have any...

Is this a 17 code? I have this list of codes and I wonder if its 17 or 71? I'm confused. Isn't the first blink a "10" and the rest units? TIA

Howdy friends! Anyone traveling between the Bay Area CA to Central/South Texas anytime soon? Looking to get an engine delivered if possible. LMK!

With a sad heart I have to report that the 1997 Tacoma we have that has 433K miles on it has a blown head gasket or a cracked head. ( have not torn into it). Looking for a used engine for one here in VA and was wondering if there was a local source for a good engine someone would know about.

New setup, only bolted on for mock up. The manifold is setup for a 50mm wastegate and is divided. Turbo is identical to the wits end setup but has a larger .88 open (non divided) exhaust housing that has been polished. Located in Flagstaff, Az. $2000 shipped in the lower 48. This would be a...

Used Clean Good Condition $15.00 +$10.00 ship lower 48

agreement I had with the machine shop was that I supply the parts and they do the work (they said parts were hard to get). So I got the cam, gears, lifters, pistons, rings and seal/gasket set and dropped it all off. when I got it back there was a few bits left over, some of which I've identified...

Few weeks ago my truck developed a pretty bad knock that was coming from near the passenger side valve cover. Did a lot of research here and was convinced I was in for a broken valve spring and maybe a new motor. Turns out the belt tensioner had failed and was the source of the knock. Glad...

Finally wrapping up this rebuild project which of course turned into a rabbit hole. Replaced all coolant hoses, new Toyota OEM clamps, etc. Reinstalled radiator this morning, added coolant and fired her up, and I’ve got a steady drip coming down the front driver’s side of the engine. I...

$75 shipped

FOR SALE PARTOUT Pulled Engine and Trans from a 1997 FZJ80 40 yr Ann with 190,000ish miles on them. The truck drove fine in the months I drove it daily but needed work. -This part you can skip. Just a "why'' to parting out.- upon finding out that I needed to redo the HG and timing guide...

$200 shipped

looking for an early 2H engine manual 1980-1985 version, not the later 2H/12HT version shipping to Helena MT

Pick up only (you arrange). $3.5k - Rebuilt 1FZFE with all yota parts except in a few places (cometic gasket, ARB head studs, and crank bearings are mahle, water pump is probably AISIN, oil pump cover has SS torx screws). Machine work done at Mt High Performance in Arvada, CO (the machine...

Hello, just noticed my firewall insulation was all torn up with rodents droppings. The weather is cold here in So Cal at night but this is the first encounter although my LC 100 have always parked outside. Any suggestions ie traps, rat poison and is the isolation hard to replace? Thanks !

Does it matter what radiator fluid I use. 1983 FJ40. I'm using Valvoline for Toyota but it says 1990 and above.

These are new take off parts from engines that were converted for marine use Two right side mounts $100 each Three isolators $60 each