engine

Looking to remanufacture an early F engine from a 67' FJ40, so need a machine shop / mechanic around LA/OC that does good work. any recommendations? also considering just swapping to a remanufactured 2F engine, but unsure of the procedure and compatibility on my FJ. all recommendations &...

Selling my 245k mile 1fz that I just pulled out of my 96 80 on Saturday. It ran and drove perfect, temps and oil pressure were spot on, no CEL. Drove 6k miles out to southern Arizona and back in April of this year. The only downside is it leaks oil from everywhere, pretty sure it has never been...

Have multiple distributors from various 80 series cruisers, all of them came of running trucks 93-97 variant with the 1fzfe. $100 plus shipping.

Hey guys! So I have a 150 Prado with a 3L 1KD engine and 120k miles. For the last few months there has been an intermittent rough idle with a P1605 code. It happens when the engine is warm, in drive and the brake pedal is down (or handbrake). The engine starts to shake and a small hissing...

$750, buyer pays shipping. I have shipped a few of these thru Fastenal. I make a box and put it on a pallet. I have this extra and want to offer it to the community. Professionally rebuilt, magnafluxed, and ready to put on — 2F casting 61031. I will provide paperwork w/ receipt. After the...

Looking for a junk or blown 2UZ. Really need it more for mocking up some parts so doesn’t need to be rebuildable. Could be just a block for what I am doing. Willing to come grab it from within Colorado or surrounding states.

My prado accelerates very slowly and slows down drastically when going uphill even with the pedal all the way down. Injectors and fuel filter has been replaced, and turbo was checked to be fine. I'm thinking it could be the map sensor or SCV, but if anyone has any other ideas on what to check...

Howdy all, I was reassembling the fuel rails on my 2000 Land Cruiser when I managed to snap the head off one of the bolts for the passenger side fuel regulator. Normally this would be a bad situation, but what's made it much worse is that I'm about 90% certain that the bolt head went into one of...

Sold: -Roof rack -All lights -1 out of 8 seat belts -Washer fluid tank -Throttle cable -Airbox system -Battery mount (battery available) Parting out a 2000 Toyota Land Cruiser. Damage to entire passenger side except third down window.. Everything else is in good operational order though...

Hello, looking for a crank pulley in good shape, hopefully local to Denver so I can pick it up. THanks!

$750, buyer pays shipping. I have this extra and want to offer it to the community. Rebuilt and ready to put on — 2F casting 61031. Engine this came from was seized so I couldn’t rebuild but found another.; hoping someone can use it. Thanks.

1KZ-TE engine for sale, $2500 obo. Removed from 1995 KZJ71 Prado. Approximately 165,000 km when I pulled it. Engine, radiator, air box, a/c compressor all included. $2500 pickup only, Pueblo, CO. Frozen engine caused me lose all compression. Pulled the head, it was warped. Replaced the new...

About once a week for the last month, I've been hearing a noise after the engine starts. It lasts from 2-10 seconds. Kind of a ticking, metal on metal rubbing. I have not been able to catch it to take a video. Until today that is..... The difference is that the noise didn't stop once the...

Looks like the previous owner was going to do an engine swap and they removed the old (original) frame side mounts. I’m assuming lots of fellas out there have removed these when doing motor swaps ? Price with shipping to 97304. PM me or reply here. Thanks everyone!!

Looking for a 3fe for my 1992 fj80 lower in working condition.. Im located in the Austin area but willing to travel a little ways to pick up as well Let me know if anyone has one thanks in advance

Asking $30 shipped. Came off a 1998 Lexus LX470 with 197k miles. No APPS, TPS or IAC is attached or included. No hoses or wires either This is just for the throttle body itself. No issues with it. Thanks for looking!

Engine, ECU, Harness and wiper motor $2000.00 OBO I am selling my 3FE that I swapped into my FJ60 4 years ago, the motor itself has about probably 270k, I bought the engine as a takeout from another swap from Cruiser Matt after my 2F lost a cylinder. He replaced the bearing on the lower end...

Just sold the last one we rebuilt, but have 2 more we are looking at acquiring. If your interested, let me know!

I’m preparing to pull my 185k mile 3FE & A440F for an LS swap. Engine is still in the truck and those who are local are welcome to come hear it and go for a ride. Runs perfect, burns zero oil, and only leaks a couple drops a week. Includes: complete long block engine and accessories...

Ok everyone I am looking for advice… I am a first time 80 owner. She’s a 95 with 160k. Anyways I noticed a while back that sometimes I would get a rough idle/shake. Thought nothing of it. Few months go by I get an O2 fault. Intake hose was falling apart. Got a new hose, new air filter, spark...