driver

Hi, the power window switch panel on the driver side has stopped working on my 2001 Cruiser. And to make things worse, the driver window was down and I cannot close it. None of the switches work, can't control any window, the central locking system or switch to disable window control. All other...

Went to pick it up and the new OME 2.5 lift and its leaning toward the driver side. Its too much to ignore. He said the A and B springs are fitted correctly. Any things you guys have done to straighten it up?

Looking for a 1989-90 Cruiser that's been well-maintained and with minimal or no rust and excellent condition. Closer to factory-original is preferred, but willing to consider typical mods. High-mileage is no problem with documented service history. Only other stipulation would be that it be...

Small rust hole where bolts to body on flat part. was painted by a previous owner some years ago I travel between mobile and as far east as crestview so I can met. Even as far north as huntsville It came off my 78. I went back and forth on if I should have patched or buy new. Im tired...

Has anyone gone from the beast to the mini beast and how is it for long trips?

Hey guys, Over the last week, my 95 FJ80 has started knocking or thumping (felt through the foot rest) at various speeds between 28-55mph. It is felt through acceleration and de-acceleration at roughly the same speeds. I can replicate it easily going through the speed range. It seems to be...

Is for a temporary fix so I can drive the truck Around until I have the means and the time to fix it Right... Thanks in advance.. Ricky

On my 2007 tundra I have replaced driver side CV axle needle bearing with bushing to help control vibration and shaft float common on the front differential. East Coast Gear Supply offers bushing for Tundra and other rigs. Since the front axle is same except of length. This should work for LC200...

I am a big guy 6'5", I was wondering if any of you other tall 62 owners out there have thought about removing the foot rest on the driver side to give your leg some extra room to stretch. Is it just empty space under there? Grinder and a cut off wheel, then weld in a patch maybe? Idk chime in if...

Truck is getting ready to go out for paint. Looking for a good driver's FJ60 fender. Prefer local-ish (Seattle or surrounding areas). Truck was converted from 62 to 60, and the drivers fender was converted some how? The headlight trim doesn't really fit this bracket (it sticks out). I bought the...

Came out from 1997 Lexus LX 450 with 150K miles. Front and rear driveshafts.

Hey everyone, I've got an '89 FJ62 that I need to replace the driver seat as the seat frame is bent to hell and there are not many, if any, options for seat repair in Montana. Would anyone know where I could get a tan driver seat or is anyone on here willing to part with one? Or, what are...