brake

I need some factory unions for front and back of 68 fj40 all drum breaks I think rear part number is 086-77A. Front 086-10A and still have most of rhe f motor factory complete but torn down also clutch and factory Clutch and pressure plate and bell housing

has any one looked into this type of system? https://www.hydrastarusa.com/pdfs/HydraStarSalesSheet.pdf $550-700 1000-1600psi 17.5 Amp electro hydraulic system for trailers. i'm thinking about converting a conventional rear disc with parking brake to my trailer. there are calipers out there...

First I would like to thank Brian Jowett (@bjowett ) for figuring out that this is possible and providing some of the parts at a better cost than available anywhere else. Second I want to thank Camelback Toyota and their parts department. They have gone above and beyond looking over parts...

Hello, I am doing a frame off restoration on a 1982 fj40. Now that the body is off I am addressing the emergency brake problem. It is completely stuck and is not the cable. This is the later style emergency brake. About to take the rear drums off but just wondering if since it is all one...

What do you guys think about replacing the soft brake lines as PM? They are 20 years old, seem to be holding fine, and have some superficial cracks. I am going to do some brake work and thought now would be the time if I'm going to do it. Thanks Russell

Anyone know of a kit that replaces the stock brake lines with extended braided for st least a 3 inch lift?

I've been searching for extended brake line options and have found several threads about using T100 / tundra lines. The only issue is that I don't know if tundra is for the front or what. I don't really need to go the SS route and only need a few inches extended. Can someone chime in about...

I am having an almost identical, frustrating experience to several other posts and need some ideas please, after reading of similar woes on many posts:SPONGY BRAKES! 1966 FJ45 body off restoration,recently reassembled but having serious brake gremlin issues HISTORY - upgraded brakes from...

Hey everyone, I just changed the rear brake pads on my 97 FZJ80 (they were really worn) and after replacing, the ABS light stays on. I disconnected the battery for about 3 minutes...no dice. I did have to compress the caliper and that caused fluid to leak out of the reservoir but I drained...

I bought a new brake booster from @Racer65 and finally worked up the nerve to install it. Dual Diaphragm Disc Brake Booster for Land Cruiser FJ40 FJ55 FJ60 My firewall is Swiss cheese from the original master to the 4 bolt non-ABS 80 master I was trying to make work non boosted. Well...

I purchased from performance brakes for the front of my 1994 FZJ 80. I never got a chance to install them. Two premium black dimpled and slotted front rotors with premium metallic pads. Cost alittle over $200 brand new. Selling for $150 plus shipping. They are heavy so I prefer local pickup in...

1976 FJ40 Front disc backing plates with brake fittings and small brake caliber lines. These are in very good shape. Slight surface rust in some areas but no cancer. $110 plus shipping

I have an intermittent problem of lack of braking power + hard pedal. It is maybe once every 10 braking. I did all the tests recommended to check brake booster & vacuum, but could not identify the problem. Pressure seems to hold well. One thing is odd though. When I start the engine after...

So I changed the rotors and brake pads front and rear. I used stock rotors and TRD pads (front and rear). I also changed the brake lines to stainless steel braided lines. The pads were making intermittent noises for first week but have finally stopped now. Overall, I wish I had gone with an...

Anyone here know where I can get a rear cylinder rebuild kit for a 79 fj45 full floater axle? I tried the OEM part number 04906-36040 but it is discontinued.

I had my rear brakes done yesterday and smashed them to check the parking brake as it has never worked. They said the canter lever that basically pivots to tighten the pads when you pull the handle is froze up. I can't seem to find this part anyone able to help? Thanks again!

5 sets to choose from, all 76-80, bolt-on junction block type. All are west coast rust-free. $200/pr plus the ride. No PMs. Junction blocks available separately.

I'm a relatively new 96' FZJ80 owner and it's my first post here so excuse please excuse me being a complete novice. My brakes went spongy/soft suddenly at a stoplight, and if I pump a couple times they firm up (not always), but it doesn't hold and the pedal just slowly sinks to the floor. I...

I'm in the process of a complete brake system overhaul on my '93 FZJ80. I had a near-miss in a panic stop a few months ago and have done a bunch of work on them since then, but they're still not what I would like them to be. As a part of the overhaul I bought 4 used calipers and am rebuilding...

Anyone explored, or installed a 'Red Line' front brake kit on an FJ62? I have an '88 FJ62 that I'm looking to 'update' the braking performance overall.